Forum Replies Created
-
Posts
-
Re: is this right?
I’ve offered 99p with the condition he comes to Scotland to teach me.
I’ll let yo know if he accepts….. 😆
Re: Creda T622CW tumble dryer ( condensor)
They are thermostats. One is self resetting (for controlling heat) and the other is one shot (safety stat).
Both should be short cct. Disconnect them to test.
Re: Bosch WFO2460 Not filling but will rinse and spin
CJAPeterborough wrote:
does it haot valve?
Not sure what you are asking ‘:?’
Does it have a hot and cold fill hose?
Re: Servis DMPDC H8 module small resistor value.
I seem to remember something from when I did work for GBDAR.
A mod from Servis about resistor R1 going open cct and causing dead machine. Had to replace it with higher wattage.
I cannot remember what modules it was on though. Might jog someone elses memory though.Re: Christmas, more of the same for 2009……
The board is very quiet this morning……
Must be a lot of hangovers getting nursed. 😀
Re: Error code E20 on Zanussi ZWD 1471S
The element would be easier tested in situ(sits inside metal trunking across top of machine). Cleaning the condenser requires splitting the cabinet and removing the back half. 1 screw either side at bottom centre of appliance behind plastic cover, 3 screws at back corners(bottom 2 at drainhose side) and 2 at top in middle which you will see after lid removed. Condenser is plastic part that sits below dryer fan motor.
Power off if trying this youself please!
Re: Whirlpool G2P90F/SS Oven 854184615021
No base element in the lower oven according to SIOS Disk.
Doesn’t seem to list a fault code for element failure.Stick a temp probe in and see if stat is switching off too soon.
Re: Any reccomendations for a tumble dryer??
mstar wrote:My wife for xmas is looking for a tumble dryer
If I did that I would have to be wearing a tin hat and body armour. 😯 😀Re: Any reccomendations for a tumble dryer??
What about a Whiteknight 77AW?
Should get one for £230ish
Re: Whirlpool AWZ 7813
Unfortunately there are 5 different versions of the AWZ7813. You need to find the 12nc number, starts 8575……..
However it looks like the plastic casing only comes with the PCB.
