[Beever]

Re: Commercial vehicle insurance

I have a Vauxhall Combo 1700d, a Vauxhall Vivaro LWB High Top 19cdti
and a VW Golf GTTDI 130 all on one policy with a company called A Plan in swindon. The total bill with a named driver of 26 £844.40 Fully Comp
will post phone number shortly.

Hope this helps

[Beever]

Re: Just a quick note to introduce my self

Hmmmm

u must be X BSH?

Who are u?

Regards , X 70780

[Beever]

no it is unlikly that this fault is the pcb, this fault is a common fault, it is the analogue pressure switch (the black on not the brown one) Part no 182238
regards

Ian B

[Beever]

Is it possible that this appliance is in a damp enviroment ie a cellar. the pcb is easly damaged via damp/ moistre. be careful if ur replacing the pcb as this will happen again if in a damp place!

[Beever]

Any probs let me know but that should sort you out!

[Beever]

remove the front panel at the bottom and remove the pipe from the sump to the float switch, this will be blocked up, causing the appliance to not fill with enough water to allow the heater to come on. Usually this pipe once clear will clear the fault, if the blockage has backed up to the float switch, replace it part no:- 482937

This will sort out the problem!

[Beever]

some of the wash pumps on this range have a ptc start for the wash pump, it is not un common for this to break down under load causing a burning smell.

[Beever]

If you had forgotten to plug the door lock back in you would have the ready light flashing.
The active light flashing indicates that the inlet tap is closed, or the water pressure is less that 1bar @ inlet valve. IE pipes kinked, or strainer is blocked

🙂

[Beever]

part no 264877, you can usually clean up the contact on the rear of the heater relay and re solder it.

[Author]

Posts