[BEKOBOY]

Re: Beko CFD6914 S fridge evap sensor

You have to change the two sensors listed below,

Evaporator sensor kit part no 4394720185
Air temperature sensor part no 4394720285

[BEKOBOY]

Re: Bosch intergrated d/w

Thanks, I know its a off chance question, I’m going back to change the water counter tomorrow and hope that will solve it. The epprom requires an exact number of impulses for it to fill and think its faulty. Customer is trying to find the model so that will help if it fails…

But thanks for the imput..

[BEKOBOY]

Re: Beko Lamona Dishwasher HJA8362 – No heat

Hiya mate, you must have an NTC fault send me your email add and i will send you the the test programme

[BEKOBOY]

Re: Any Engineer looking for work in the North West?

Hi there, am based in Liverpool and looking for work ????

[BEKOBOY]

Re: Leisure (Cookmaster) CM 10 FRK – front control panel rem

You have to remove the complete top in order to gain access to the facia panel top fixing screws…bit of a bad on but the only way,

[BEKOBOY]

Re: beko washer model wm6133w

I would check the heater NTC as it can play around with the programme if it gets a high resistance…..

[BEKOBOY]

Re: BEKO WM5140W JAMMING

Yes mate this is a rinse hold, you have to select drain or spin to finish the cycle…..

[BEKOBOY]

Re: **KNOWN ERROR CODES**

I will post all the beko test programmes for all appliances soon, will be a large file so might sent it to ken to post it…..

[BEKOBOY]

Re: Beko wm5120s

Check the drain pump impellor, as if it gets obstructed, it will give the electronics o the unit to play up and lock programmes. Quyite a common fault with this model.

[BEKOBOY]

Re: Beko WME7247W showing error code e18? what is this?

The machine had experenced an un ballance load hence the E18 error code.

[BEKOBOY]

Re: Beko AWM510 No start

That fault sounds like a faulty NTC mate,

[BEKOBOY]

Re: beko

Hi Lee,

I have sent the info to your email, full diagnostics and wiring diagram

Cheers,

Steve

[BEKOBOY]

Re: beko

Never had this before, but wii email you all the info to help you…

[BEKOBOY]

Re: beko wma510w

Hi there, you have to change the PCB as it is logging a foam detection which will activate extended rinses up to an additional 27 rinses can be added. If you change the pcb to the new type, it will eliminate this problem the part number is 2822640073.

Hope this helps you…….

[BEKOBOY]

Re: Can any one help ????????

Thanks very much for for all your help, if you ever need info on BEKO ELECTROLUX B/S/H GAGGANU MIELE appliances let me know and i will help you out.

Thans again

[Author]

Posts