Forum Replies Created
-
Posts
-
Re: Zanussi Washing Machine ZWF1621
Had the same prob with zanussi washer dryer changed the green inlet solonoid and that sorted it .
Tom.
Re: zanussi dishwasher leak
Sorry for late reply big chris thanks for all your help but I have given the dishwasher back to the customer and told her to call back the guy that fitted the tank as I have spent way too much time on this already.I hope I can be of help to you someday.
Tom.
Re: zanussi dishwasher leak
yes its the side tank with the water softener. I dont have the part no. as it was another guy that fitted this.The machine completes its cycle every time its as if it gets blocked for a couple of seconds and sends the water into this back chamber. I took some water out of this back chamber today and took note of its level and started a cycle and it completed this without rising.I then ran the cycle again and it rose straight away and leaked out of the chamber thats why im wondering about the side tank
Tom
Re: zanussi dishwasher leak
thanks big chris , could the water be getting into the back chamber from the matrix as this problem only started when the new matrix was fitted.
on the bottom of the matrix there are two sets of three holes , the centre of each set is for a screw and the other two seem to be going on to pipes, one set to the salt chamber and one to the back chamber.tom.
Re: zanussi dishwasher leak
Thanks bigchris I tightened the nut and that seems to have stoppped the leak from under the base but now have spotted one from the compartment where the inlet sol is . there is a hole about 20 mm diameter in there I think its an overflow and thats where the water is coming from. this leaking prob only started when another guy replaced the matrix . any help would be greatly appreciated.
Tom.
Re: zanussi dishwasher leak
cheers , i think it might be the rubber seal on the base of the dishwasher.
can this be changed and if so how do you go about it.tom
Re: zanussi zk5648
Cheers spindoctor sorry for not replying sooner dont know the exact temps I havent been to the customer yet but she said the freezer compartment seemed ok and the back of the fridge compartment there was a build up of ice more so at the top.If it is what you say I think I might tell her to get in a zanussi guy.
Tom.
Re: whirlpool hob element
No prob Mike most of the stuff I use is from Qualtex and I agree his site will be helpfull for finding what parts look like . Thanks again.
Tom.
Re: whirlpool hob element
Cheers Mike I have since found the part no. 481225998408 .It has two coils . My supplier cant find a generic part for this and the price for a genuine part is 175 euro + vat so customer is going to work away without it for now.Thanks for the info on element man may use him in the future.
Tom.
Re: whirlpool hob element
Cheers steve my supplier says he needs a part no. or service no. so he can send me the correct pattern part.
Tom
Re: module for vtd60g
Hi my supplier had sent me the wrong module and thats why I couldn programme the module . I have since recieved the right module and programmed it but all that happens is when I press the on/off button ON appears in the the display screen and when I select a drying cycle all I get is three beeps when I press the start button. Does anybody have any ideas as to what is wrong now?
Tom.
