[bzz67]

Re: Beko WM

brushes are common

[bzz67]

Re: W/pool ADP4501/5

pressure switch, on side of sump. rubber diaphram probably clogged up. twist fit, easy to remove and take apart

[bzz67]

Re: Yet another gripe at connect.

phoned them three times to put printable version button on statement page. they have done that now, but it only shows the whole amount thats owed including this months, when you uncheck the boxes the total stays the same. i have phoned them again and told them, so hopefully you will soon be able to print off just one months statement

[bzz67]

Re: EMW, 6 MONTHS,NOW NOT 12?

always found EMW to be great, infact i have always given 6 months guarantee on all repairs, apart from recon pcb’s.(12 months). so 6 months is fine by me. i hate doing a 30 mile round trip to find we fitted a recon pcb 11 months previous & its gone again, then another 30 mile round trip to fit another one for no charge. EMW & us engineers lose out just because the board is rubbish.

[bzz67]

Re: ind dryer

usually changing that barrell shaped cooling fan sorts that fault, they tend to go out of balance. try running it without fan to see if it cures it.

[bzz67]

Re: I’m stuck

had a fault like this once, ended up being a poly bag in the circ pump impellor, reducing the water pressure to high pressure switch.

[bzz67]

Re: DFI 45 candy slim dishwasher

thats great thankyou

[bzz67]

Re: VTD00Peed off!!

shaft kit now comes with rear seal and front pads, seems to stop it scraping so hopefully pushes it foward slightly

[bzz67]

Re: Hotpoint FDW60 dishwasher.

i think this machine has a water diverter on the circ pump, maybe a fault there.

[bzz67]

Re: any idea how old this is

sorry forgot to mention that its a Hotpoint.

[bzz67]

Re: Whirlpool AKZ350 Oven Fault

481221478894 Control unit GEMINI 2
this the correct part number, but it dosnt say if its configured or not.

F03
CAPRICORN not properly
configured
Replace CAPRICORN

it only says this about the fault. tells you to replace and not configure!!

[bzz67]

Re: Whirlpool AKZ350 Oven Fault

sorry just had another look, going to need service number next, there are a few different ones

[bzz67]

Re: Whirlpool AKZ350 Oven Fault

521 0 4812 214 58379 Power unit Basic SAM
521 0 4812 214 58562 Power unit programmed

this is from the whirlpool site, looks like you may have the unprogrammed

[bzz67]

Re: what do you think of this machine !

Thanks for the info guys, i will give it a go then.

[bzz67]

Re: LG WM1480FHD

good to see the sensor is now available on its own, the last time i fitted one, it came complete stator.

[Author]

Posts