Forum Replies Created
-
Posts
-
Re: BAUKNECT INTERLOCK CHALLENGE
no door not locking looked inside,not repairable.i’ll see if i can get a picture Dave.cheers
Re: BAUKNECT INTERLOCK CHALLENGE
thanks Dave,i tried what you said & they said the machine is 22 years old & only the timer is now available,so thats the end of that then unless anyone got an old one left on the shelf somewhere.
Re: wpl td no heat
I SEEM TO REMEMBER HAVING THIS FAULT BEFORE.IF YOU HAVE ONLY METER TESTED THE ELEMENT, TRY REPLACING IT OR PUT MAINS DIRECTLY TO IT.BROKEN ELEMENT CAN STILL SHOW A RESISTANCE ON A METER.
Hooray. The machine is working, it was a broken wire in the motor loom, the sleave was fine but the wire was broke where the loom cable ties to the underside of the drum. thanks anyway for the sugestions.
Re: INDESIT W103 WASHING MACHINE
first have you reset the program by swithing off for 1 minute,select zero then switch on until neon has done its little rapid flashing bit.always test motor,heater & thermistor before ordering pcb.try emw for board then if its not that at fault they will only charge you for the test.
Re: Qualtex ARM 20
A QUALTEX REP TOLD ME RECENTLY THAT THEY HAVE CURED THE FAULTS ON ARM20 NOW, AND ARE ACTUALLY MAKING THEM FOR HOTPOINT.
Re: Connections DVD
CONNECT I T DEPT TOLD ME THAT THEY ARE GOING TO PHASE OUT THE DVD SO I NEVER USE IT ANY MORE.
Re: WMA Drum Screws breaking?
the best way i have found to remove a broken screw `like the ones that snap on modern hoover counter weights`, is to cut a slot in the end of the thread with a drimmel,dont worry if you cut the plastic tub a little.then you can use a flat srewdriver to wind the srew though.
i have never seen snapped screws on a wma but i always use a cordless drill with a torque setting to tighten them.
if you split the tub halves don’t forget to replace the tub seal.Re: whirlpool parts
the tumble dryer stat can be removed without taking the drum out if you have a small ratchet with torx driver bits, ( OTHERWISE ITS EASIER TO REMOVE DRUM )
Re: whirlpool parts
have you checked the green exhaust thermostat at the front of the tumble dryer, part number 481227128369.
Re: bosch wfo2064gb plastic tub dismantle problem
Thanks Martin.Already had the drum assembly out so i took it outside and flushed it through with a hose pipe.This worked well, and not too long a job.Cheers.
Re: LG wm1480fhg LE fault motor!
Just like to say that i have now fitted a new motor and all is fine.took a look at the hall effect sensor on the old motor but could not see any physical fault.
Thanks to everyone that helped.
