[chezza]

Re: ancient washer Electra AWF682 drain pump

The original pump was 481936018139 ( just remembered that) and that comes up on qualtex but with a special order
**just googled that number and someone on amazon has one available**

[chezza]

Re: ancient washer Electra AWF682 drain pump

That is an old Philips made machine. If you look for a pump to suit model awb082 you should be in luck. Connect show one but special order, I am sure others should have one also.

[chezza]

Re: Bosch V6320X0GB/02 E13error

Thanks for the help. The insulation tests were all ok, so fingers crossed for the interlock. Thanks again

[chezza]

Re: 2016 CONFERENCE

Thanks 🙂

[chezza]

Re: 2016 CONFERENCE

Are registrations now closed? I am trying to register to attend, yet unable to get any response other than a message stating “sales ended”

[chezza]

Re: URGENT help required – HOTPOINT washing machine

http://www.whitegoodshelp.co.uk/low-wat … -machines/

This might be of use, check the may2011 update

[chezza]

Re: URGENT help required – HOTPOINT washing machine

What is the water pressure like? A low water pressure will allow water to seep past the diaphragm in the solenoid and my guess would be this.

[chezza]

Re: WTA listings

Thanks Lawrence, I have received the form.
Eddie

[chezza]

Re: WTA listings

Thanks Ken

[chezza]

Re: WTA listings

Perhaps someone could advise how to join the WTA? I applied in March, followed by 3 seperate enquiries to 3 different people, and have had no response to anything yet… perhaps I have been unfortunate

[chezza]

Re: Scottish borders/ Edinburgh vacancy

chezza wrote:Due to increasing workloads, we are looking for an additional engineer for a borders based company, covering mainly TD and EH postcodes.
Minimum requirements, driving licence ( minimal points considered), with ability to work unsupervised on washers, dryers, dishwashers and electric cooking, also 1st line refrigeration. Further skills an advantage.
Please contact either by pm or email eddie.pritlove@btvc.co.uk

Just to add, would consider part time for the right candidate

[chezza]

Re: CDA FWC150ss

If the fan and compressor are both running ( and not cutting out)then it sounds like a system fault- gas leak or restriction in the sealed system and will need specialist repairs. It wont be the sensor unless you are also getting error codes in the digital display

[chezza]

Re: CDA FWC150ss

Arbo100 wrote:Hi
I have a CDA FWC150ss wine cooler.
It gets cold on the outside but is hot on the inside.
I’ve taken all the covers off I can & gave it a good vacuum to clear all the dust but it still will not cool on the inside. It goes up to max temp, think this is 18c

Think this maybe the thermostat??

Thanks for any advice.

Regards
Dave
Is the compressor running? If so, check if the cooling fan behind the compressor is running – it should run whenever the compressor runs. If the compressor isn’t running but the fan is, it may be the compressor that is failed…these are probably the 2 most likely things

[chezza]

Re: CDA wc140in

faulty heater sensor, will almost certainly be broken door wires, especially the thin ones

[chezza]

Re: New Hotpoint top loader for sale?

Wow, that’s a blast from the past. Must have taken hundreds of them to pieces over the years

[Author]

Posts