Forum Replies Created
-
Posts
-
Re: Candy CDi1012 fault code
Sold as graded a couple of years ago so no prod. number unfortunately. as I thought , just got off the phone to the customer who says its a constant flashing of the four leds and no gaps 😥 .
TCRe: Hotpoint Condenser Tumble Dryer tripping
I’ve had the heater mica insulators on these get worn away on the lower edges of the heater terminals. Usually accompanied by the sound of a loose fan :rolls: . Pretty sure its caused by the vibration and thin Mica.
TC
Re: Bosch WFE2021 time fault?
Had one of thase today giving strange faults.
Keeps stopping during wash customer presses start button and it carries on for a while. I checked it on spin and it did the first part fine, got to 4 minutes and quickly changed to 1 minute.
Meggered the heater and motor, both well ok. Checked carbons, loads on them.
Could ntc cause this one?TC
Re: ISE2 version 2 no motor regulation
Any news on the boards arrival from Vestel?
Got a very annoyed customer I need to get off my back 😥 .TC
Re: How the ****did that get in there
Goatboy wrote
The most spectactular thing I every saw, was a fifty pence piece, that had turned sideways in between the inner and outer drum, and it had cut through the metal outer tub like a tin opener!
Sliced the thing clean in two, and made a spectactular mess
Wasn’t a Servis was it. I had a similar experience but the 50p was still stuck in the groove.
Who said 50p’s couldn’t dance 😀
TC
