Forum Replies Created
-
Posts
-
Re: Siemens HB75RB550B/05 oven trips RCD
It’s a lot less than a couple of Meg…nearly a full short to earth:-(
Re: Bosch heat pump
Done a couple where I’ve just had to remove the PCB and can access it from the side. Not 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} if it’s the same model though.
Re: the daft things engineer do !
How many have taken the faulty part out, put it on the floor next to them, got distracted and refitted the faulty part, only realising when you tested the machine and it was still faulty . 😳 🙁
Re: Beko WMB61221w hangs on rinses
😈 Bloody Connect only supplied the wrong motor!!!!
By chance we had the 1200 model in for repair, 7 wires on plug, checked the recon and 8 wires, 7 way on motor. 😈 Found the old motor in scrap pile….guess what.Re: RAW Washing Machines
Ha, I remember Phil A. Logics and 95’s a fiver, anything newer £15…..and don’t argue 😉
Re: Hotpoint DWF50 door seal
Cheers Jim, must’ve been wearing me magnifying glasses too, it’s about 1″ shorter either side B-/
Re: Hotpoint DWF50 door seal
I know this is an old thread but wondering if another seal is available for this machine as c00141317 is about 3″ too short either side( or 6″ on one side;-))
Re: AEG Lavamat Turbo 16830 Stops Drying After 15 mins
Anyone have access to the link mentioned above. Need diagnostics as the machine is cutting out after a couple of seconds whatever it’s on.
Re: Bosch wvd24520gb/01 washer dryer module lock down!!
All triacs looking fine. One of those boards with the see through rubberized gunk sealing everything though 👿
Re: Bosch wvd24520gb/01 washer dryer module lock down!!
Can’t see anything visibly blown but must admit I was looking with the naked… readers 😉 Will get my magnifier out and look again.
Re: Bosch wvd24520gb/01 washer dryer module lock down!!
I know it’s an old thread but has anyone else resolved this fault.
Same symptoms, display just showing backlight on a machine to recon. Meggered machine all ok, didn’t think of brushes at the time so tested it with a a board /facia froma donor machine. Machine sailed through first was with no problems or undue noise/ arcing. Tried it on second wash and noticed no motor action after a while. Turned of, check the brushes and well down. Changed them and the display has reverted to backlight only.
Tried the donor machine motor, checked the edge connectors, buzzed out loom…all ok. Presuming that the brushes have taken the pcb out as the old motor test through fine.
Surrounded by bits now and thoroughly peed off as both these machines were mint. 🙁
Re: oven removing table
I’ve had an old Hotpoint one for years which always gets the card table comments as the top is green. Tubular lags, 3 position. occasionally have problems with ovens fitted for the vertically challenged but ace for most.
Re: Connect V Qualtex prices.
For a larf check out the price for a creda 17051 do 😕 or handle on connect. Phew!!
