Forum Replies Created
-
Posts
-
Re: hotpoint tumble dryer tcd970 dead
I don’t know if this will help
Models fitted with A1 type Module
The one-shot thermostat is wired into the Neutral supply of the module. If the One-Shot
Thermostat operates and opens the machine will be ‘dead’ and the display will be blank.
A fault code will NOT be displayed.
Models fitted with A2 type Module
If the 1 shot thermostat operates and opens, the machine will continue with the cycle with no
heat.Re: hoover wdm130 fills continuosly instead of heat
PM your email and I can send some info when I get back this afternoon
Colin
Re: HPT TCFF87C6G Ind co 95799840000 Ser 209264134 condenser
F04
No rise in temperature detected: Check Heater circuit including Cycling
Thermostat, One-Shot Thermostat, Heater and wiring. Also check Rear NTC
Thermistor Open or Short Circuit. Check Rear NTC (attached to heater Frame)
and attached wiring and module connections including relevant module
connections.
More info sent to your email addressColin
Re: BEKO DCU 8230 No heating
I have some service info on this one, let me have your email address again and will send it to you
Colin
Re: Beko wmb71642. Sn 11-419138-12
I don’t know, looks like there are 2 boards listed and presume that the early board might be 2824447430 ?
Re: Beko wmb71642. Sn 11-419138-12
Are both boards identical as it looks like the part was modified last year
Colin
Re: indesit WIDXL 126 uk leds flasing
NTC dryer sensor open or short circuit, should be about 20K at room temperature
Re: Belling Cooker 635MH Halogen Element
You could replace with a normal ceramic hotplate on this one, Hpt C00228943 should fit
Colin
Re: Bosch CL 726 condensor dryer
I don’t know if this will help, their service info is here.
http://www.whiteknightrange.co.uk/white … ad-SM.htmlColin
Re: Beko WM5100w ready and wash lights flashing
The only error I can find is Ready and Wash lights flashing and spin/end light on. This is listed as PROGRAM / TEMPERATURE / SPIN SELECTION POTANTIOMETER FAILURE.
