[Criscold]

Re: AEG dishwasher module setup?

Hi Ray

I had the same problem a couple of years ago on this module, after checking the wiring it turned out to be the socket on the new board A1-A2 was reversed and had to fit the plug upside down to get it to work
Worth checking

Colin

[Criscold]

Re: indesit oven wiring diagram req

You Have Mail

[Criscold]

Re: jldw1200/911516036/04

Water leakage from the tub – sump and various
connections (pump, upper spray arm duct etc.);
floating sensor blocked mechanically; microswitch
faulty; fill solenoid blocked mechanically; circuit
board faulty (solenoid triac short-circuited); wiring faulty

[Criscold]

Re: aeg F50730 91123251701 dishwaser

I don’t know if this will help, may be worth a check

[Criscold]

Re: Tricity Bendix SI1450 Cooker Thermostat

Hi Jonty

Are you sure the model number is correct ? unable to find it listed.

What is the part number for the thermostat you have.

Colin

[Criscold]

Re: hotpoint fd97e oven er7

ER07 Too hot on the main board
1. Tangential fan
2. Correct oven installation in the kitchen (air flow)
3. Correct positioning of thermic insulation / venting
4. Main board

[Criscold]

Re: Beko DWD5411 Dishwasher drain pump not running

Looking at the circuit diagram, unless its a break in a door cable from connection 7 on connector KN2 I think I would go for the board.

Pt 1784000140

Let me know if you require the wiring diagram.

Colin

[Criscold]

Re: John Lewis JLDW1200 dishwasher -60 fault code

Could be intervention of the thermostats on the heating element.
Scale Build up ?

[Criscold]

Re: whirlpool dishwasher 15 flashes

I think this is an Eeprom Failure, The Control board software has an error and needs re programming or replacement.

Colin

[Criscold]

Re: Hoover VHV781c-80 Exhaust TOC

Have you changed the NTC ?

[Criscold]

Re: Zanussi ZDT6252 pnc 911847023 no filling

Yes that’s correct, Have you got power to the valve and can you hear a faint hum from it, if so I would remove the valve and see if its actually letting water go into the IWMS.

Colin

[Criscold]

Re: Zanussi ZDT6252 pnc 911847023 no filling

Possible and sometimes it will be OK,have you tried resetting valve yet ?

pm your email address if you req the manual for this one.

Colin

[Criscold]

Re: Whirlpool test cycle ADG7470/1

PM your email and I can send you the info

Colin

[Criscold]

Re: Zanussi ZDT6252 pnc 911847023 no filling

You will not be able to clear the IWMS.

Try resetting the valve first, sometimes this will work ok but if it locks out again then the IWMS will need replacing along with the valve.
The IWMS comes complete with the valve

IWMS Pt No.1524624036

Colin

[Criscold]

Re: Bosch Dishwasher Aquastop Valve

Hi

Thanks for the input.
Yes would have tried that but didn’t have a hose connector with me, I hope to return Friday

Colin

[Author]

Posts