Forum Replies Created
-
Posts
-
Re: Lamona HJA4620 Snr 1010303008 (Double oven)
Firstly according to the circuit diagram the Cut-Out is rated at 250deg and the Bosch one says T175 but don’t know if this is the temperature or not.
Secondly you say that the oven heated but did you check the temperature inside the oven and was the thermostat working ok, I use one of these and find good value for the money.http://www.ebay.co.uk/itm/TRIXES-Digita … 2ecf33f244
Colin
Re: Whirlpool ADG7560/2 851175615911
Normally caused by Split Seam on Lower Wash Arm and water sprayed sideways, worth checking.
Re: Whirlpool ADG7800/1
This machine has a flowmeter in the inlet manifold on the LH side of the machine and probable cause of the fault. let me know if you require any further info.
Colin
Re: Zanussi ZWG7140P
I think you will find that is the correct seal,the vent at the top is where the water fills from the dispenser-1327301014
Re: whirpool dishwasher adp7955
There are a lot of versions of this machine, have you got the service code ?
Re: Electrolux/IKEA RDW45
Have you checked bottom arm for split on the seam as this is probably the cause of the leak, Pt no 1527271009
Re: Re Zanussi ZWX 1506 NOT WASHING BUT DOES SPIN
Check the connections on the blue cables going between the facia & control modules, remove pinch connectors with your fingers and refit
Colin
