Forum Replies Created
-
Posts
-
Re: Siemens HB904 – glass door cleaning
Just to say the idea about using a scraper was a great one.
No expense needed and the glass looks (almost) like new !
Thanks again!
Re: ISE 10 1406W will not drain
Problem solved – thank you very much. A 5p piece and a piece of plastic had got past the filter and were acting as seal at the end of the outlet hose at the connection with the under sink waste pipe. Great advice from here as always !!
Re: ISE 10 1406W will not drain
Yes – the pump runs freely and without obstruction. The pump outlet hose is connected to an undersink wastepipe – that connection is the next thing to check.
Re: ISE 10 1406W will not drain
Can I just check that by the ‘pump filter’ you mean the ‘drain plug screw in’ at the front of the machine ?
Re: ISE 1406 – how to get coins out of the drum….
Thanks – thats worked now ! No sign of the 50p though 🙁
Re: ISE 1406 – how to get coins out of the drum….
Thanks for that. Have had my head right inside the drum looking with a torch, not a pretty sight from the back!, there are definately no screws though just a lot of scratches from the screwdriver.
Re: Hotpoint TDC62P not heating
I also have a TDC62
I have tried several times to get at this thermostat’s fixings but without success.
Can anyone suggest a way to access it for testing?
Re: ISE 10 door does not unlock automatically
I forgot to say thanks…this solved the problem!
One of those cases of not knowing what we didnt know…
Re: ISE 10 door does not unlock automatically
OK – so the drain sump is clear, I’ve drained the machine using the front tube, run another drain cycle as well and the door still wont open automatically.
Is this the time to call someone in to look at it?
Re: ISE 10 door does not unlock automatically
We’ve been getting F3 codes too. The drain sump at the front has had the occasional foreign object in it – I’ll check it again.
Thanks
Re: ISE10 F3 Fault
Reports today are that the machine is working fine – so thanks for the information again.
Re: ISE10 F3 Fault
Update –
Maintainance wash run at 95 degrees…only the slightest hint of suds, but I drained it down beforehand & discovered a lost gold ring in the inspection chamber at the front …could that have been the cause of the problem?
Re: ISE10 F3 Fault
Cant say we’ve reduced detergent usage – but I will check with my wife how much. We tend to use the M&S detergent tabs. Either half a tab or a full tab depending on the load.
Having seen previous posts where detergent usage is a factor is it fair to say that reducing ‘quick wash’ usage & maintainance washes might also be a factor?
