Forum Replies Created
-
AuthorPosts
-
Dave_Conway
ParticipantRe: Possible cheaper fuel ?
I had a chunk in the middle of that as well 😉
SPAM
🙂
Dave_Conway
ParticipantRe: Hotpoint CTD85/31358 Condensor Dryer
The kit is 1703607 which is either just the two stats on the heater or the two stats plus the rear thermistor, it’s not clear from the picture although the text indicates it’s all three 😕
The PCB is 1703286 (superseded kit) you will also need eeprom part number 1703567 as it now comes without one.
Dave.
Dave_Conway
ParticipantRe: tricity bendix cooker
Original part number is 572580555009 at around £23 trade from Electrolux.
Masterpart are showing one in stock at a little less 🙂
Dave.
Dave_Conway
ParticipantRe: indesit DV620 dishwasher
The base of the dishwasher has flooded in that case activating the flood protection. You could try leaning the dishwasher and see if any water runs out (towels handy ;)) once emptied it may run again.
There may well be an underlying leak causing this of course which needs investigating and resolving.
Power off if you decide to look further :zap: or check the repairs@ link below for an engineer should you need one 🙂
Dave.
Dave_Conway
ParticipantRe: Bosch WFL 2260 drain pump
Out of interest, where did you get one from in the end ? 🙂
Dave.
Dave_Conway
ParticipantRe: LG AFL WM-16225FD
Just a thought, the pump isn’t a different voltage is it as it’s supplied by a control PCB ?
Inlet valves are all OK ?
Dave.
May 24, 2006 at 1:54 pm in reply to: Zanussi washer – model FLE 1115W – programs gone screwy? #177488Dave_Conway
ParticipantRe: Zanussi washer – model FLE 1115W – programs gone screwy?
Are there no error codes or flashing lights when the machine comes to a stop ?
If not then I would also suspect the control PCB as it should detect other components that have failed.
Dave.
Dave_Conway
ParticipantRe: Whirlpool AKG 342/WP Fan Oven – No power
If it were the timer then probably not to be honest, it’s over £100 but if the thermal fuse has failed then that would be about a quarter of the price 🙂
Dave.
Dave_Conway
ParticipantRe: Another adopted oven
This model is actually made by Stoves and I have no manual for it I’m afraid.
It may be worth a call to them on 0151 432 7838 🙂
Dave.
Dave_Conway
ParticipantRe: Miele vac tube
Yep, that would be the solution 😀
Generally Miele use 35mm rods and tools, could you measure the diameter and confirm please (where the end of the hose end fits in to the extendable rod).
It may be a case of two rods being used as an extendable one may not be available in that size but I’ll check
Dave.
Dave_Conway
ParticipantRe: buffalo boiler
Alex wrote:Why would you want to boil a Buffalo?
Because it’s healthier than frying one 😆
Dave.
Dave_Conway
ParticipantRe: Hygena extractor fan ducting connector
That’s no problem.
The outlet flange is £4.41 plus carriage, there is also a non-return flap and a reducing flange available if required.
An email to spares@ukwhitegoods.co.uk please if you’d like to order any of the above.
Thanks.
Dave.
May 24, 2006 at 11:05 am in reply to: AEG OKO_FAVORIT 50750VI – compartment door doesn’t open #177224Dave_Conway
ParticipantRe: AEG OKO_FAVORIT 50750VI – compartment door doesn’t open
It involves seperating the door basically (with the power off of course ;))
Dave.
Dave_Conway
ParticipantRe: indesit DV620 dishwasher
Counting the LED’s from left to right, numerically which is the pre-wash ?
Dave.
Dave_Conway
ParticipantRe: Whirlpool AKG 342/WP Fan Oven – No power
With a test meter (with the power off please :zap:)
If you’re unsure, please check the repairs@ link below for an engineer 🙂
Parts are still available for this model also.
Dave.
-
AuthorPosts
