Dave_Conway

Forum Replies Created

Viewing 15 posts - 8,626 through 8,640 (of 12,426 total)
  • Author
    Posts
  • in reply to: iberna #130271
    Dave_Conway
    Participant

    Re: iberna

    We’re going to need that model Nick I’m afraid.

    If it’s not next to the salad bin, try pulling the oven from the housing and check around the back.

    Dave.

    in reply to: Complete door for a Diplomat Select 620 oven #129697
    Dave_Conway
    Participant

    Re: Complete door for a Diplomat Select 620 oven

    Yes, I can get them Bill but the same applies. Select 620 isn’t the model just a range of ovens.

    APL AHY etc … please. Check around the door, if not it’s on the top of the oven itself which invloves sliding the oven out of it’s housing slightly.

    Dave.

    in reply to: Proline EF9000B/1 Grill Element #130353
    Dave_Conway
    Participant

    Re: Proline EF9000B/1 Grill Element

    Part number 79X9610 is £15.61 from Brandt trade plus a bit of P&P and VAT.

    I can get if required goosey, drop me an email/pm 😉

    Dave.

    in reply to: WHIRLPOOL DRYER MOD. 3RLER5437KQ #130339
    Dave_Conway
    Participant

    Re: WHIRLPOOL DRYER MOD. 3RLER5437KQ

    Check the heater thermal fuse and thermostats as these are used as part of the circuit to keep the motor running.

    Dave.

    in reply to: Caple fridge door hinge #130254
    Dave_Conway
    Participant

    Re: Caple fridge door hinge

    Part number DK0415550 at £30.20 inc VAT and postage.

    I can order if required, email to spares@ukwhitegoods.co.uk please 😀

    Dave.

    in reply to: Corgi cowboys? #130216
    Dave_Conway
    Participant

    Re: Corgi cowboys?

    Martin wrote: do they not police the activities of those that may allow their registration to elapse and yet continue with their business in this way????????

    Not unless someone reports them I don’t think so no 😕

    Dave.

    Dave_Conway
    Participant

    Re: Hotpoint Mistral Plus (model 8596P) Fridge Freezer Temp

    Typical, two versions of the fan motor 🙄

    Serial number please Shiner.

    Dave.

    in reply to: Ariston dishwasher – detergent dispenser won’t open #130253
    Dave_Conway
    Participant

    Re: Ariston dishwasher – detergent dispenser won’t open

    You haven’t hung a dishwasher freshner on the front of the upper basket by any chance Alan ?

    Dave.

    in reply to: Whirlpool AWZ 121 on off switch?? #130182
    Dave_Conway
    Participant

    Re: Whirlpool AWZ 121 on off switch??

    😆

    Complain to them I meant 😉

    Dave.

    in reply to: Zanussi DX6453 – Flashing End Light #130237
    Dave_Conway
    Participant

    Re: Zanussi DX6453 – Flashing End Light

    As Martin says, only flash codes one to five should be displayed to the user, the others are only accessable via the diagnostic cycle.

    Six flashes is a heat time out error, I think the phone call is inevitable 😉

    You could try repairs@ and the directories for a UKW member near you as well.

    Dave.

    in reply to: Hotpoint DWF 70 Power down #130240
    Dave_Conway
    Participant

    Re: Hotpoint DWF 70 Power down

    My initial feeling is the main control PCB is at fault but I think in this case an engineer would be your best bet to be honest as it’s an unusual fault.

    You could try repairs@ and the directories, there should be someone near you hopefully.

    Dave.

    in reply to: Ariston Margherita A1124 Advantage – Problem #130234
    Dave_Conway
    Participant

    Re: Ariston Margherita A1124 Advantage – Problem

    1 flash is related to the motor speed control, either the tacho generator or possibly the control module itself. Also worth checking all connection between the two.

    Pull the plug 1st please if you’re going to have a go :zap:

    Dave.

    in reply to: Tricity Sovereign cooker #128756
    Dave_Conway
    Participant

    Re: Tricity Sovereign cooker

    No, I was refering to the fan motor 😆

    Sorry, it got a bit confusing at one point, three conversations going on at once 😉

    The halogen (which is what you are after), can you post the voltages and lengths of the tubes as someone may have some.

    Dave.

    in reply to: Hotpoint DWF 70 Power down #130238
    Dave_Conway
    Participant

    Re: Hotpoint DWF 70 Power down

    That’s a bit of an odd one.

    Does the display slowly fade out or does it just “stop” dead ?

    Dave.

    in reply to: Whirlpool AWZ 121 on off switch?? #130180
    Dave_Conway
    Participant

    Re: Whirlpool AWZ 121 on off switch??

    Complain bitterly Tony, it’s £18.99 excl on my system !! 👿

    Dave.

Viewing 15 posts - 8,626 through 8,640 (of 12,426 total)