[delta01]

Re: wf 240 intermittent wont light up

thanks guys thats brill

john

[delta01]

Re: hotpoint wd 420

iadom was right it was the brushes , also amazingly i had the same fault this week caused by a motor plug wire coming adrift on another machine
also had a ntc bad connection fault on heater thermistor the late type the small pins were coroded ( green in fact ) i changed it to earlier spade type thermistor

thanks for your input

[delta01]

Re: hotpoint wd 420

thanks iadom thats my nxt task

[delta01]

Re: hotpoint wd 420

thanks

no but i have the code book from uk white goods but it only seems to refer to the vertical lights on the facia and not the horizontal ones, but i will check out your suggestion

[delta01]

Re: CAPLE WDI 2201

thanks dave will await customers response and check out your suggestion

[delta01]

Re: CAPLE WDI 2201

hi it keeps showing each different speed in turn ie 800 then 900 then 1000 etc will not stay on any , and changes quickly ie in less than a second on each speed funny thing is when i pressed the start/ pause button it stopped on 1000 and seemed to run ok i asked customer to let me know how it goes on

[delta01]

Re: zan tce 7124 not stopping

will do thanks martin

[delta01]

Re: wf conversion problem

thanks for reply madmac funnily enough i tried that on the first conversion i could not seem to get any effect however there are three screws on these p/s maybe i just turned them in the wrong order will look at that again though

[delta01]

Re: wf conversion problem

i am going to try making a mounting so i can fit the original motor and see if it cures the prob. will let you know if it works ,it may be a while before i get round to it though

[delta01]

Re: wf conversion problem

yes i have changed the sump etc and re situated the pressure switch so apart from the motor eveything is the same inc. the control system

[delta01]

Re: zwd 16581 washer dryer just shos error in display

it wasnt dryer heaters assumed module faulty as tested all components customer happy to purchase ise 10 ,zanusie and other manufacturers will reap a heavy loss of sales due to their short sighted and greedy attempts to force customers to insure or replace machines by making them uneconomical repairs

[delta01]

Re: zwd 16581 washer dryer just shos error in display

thanks rub will look at that

[delta01]

Re: zwd 16581 washer dryer just shos error in display

my sentiments entirely will offer them a quality machineas the risk of bearing failure is high due to it being so old …… ie lg, daewoo, ise10
thanks for reply martin

[delta01]

Re: wf741 fill level too low

apparently customer complained that the clothes were dry in the middle
it seems like its not topping up as the clothes absorb water, anyhow i brought it in and will soak test it in work shop (no pun intended )
i wondered if she may have overloaded it

thanks for your reply

[delta01]

Re: hotpoint tvf760 dryer

i was not aware of this potential problem but will check it out
thanks

[Author]

Posts