[electrofix]

ok this unit seems to have a seperate programme selector sw

https://shop.ukwhitegoods.co.uk/2827…elector-switch

check the wire going to this have not becomes dislodged either end

Dave

[electrofix]

its not had the child lock activated by accident has it ?

Dave

[electrofix]

which programmes seem to be visible

was one of these programmes the last one used ?

Dave

[electrofix]

a lot of posts on google it says its a flow E04 is a flow sensor problem

since the motor is also a sensor its an option

try a cycle your out of the box fix might just work

to see the impellor i use a small round mirror and a bright led torch

all it would take is a piece of plastic to change the electrical current when its rinning to make the module think its low on water. if its low on water it wont turn on the heater

after that its change parts time but which one thats the problem.

Dave

[electrofix]

typical hoover no info like that

stat should be part no 41022107

£11 + vat on Qual

Aswo have a compatible one for £4.57+ vat

Dave

[electrofix]

first thing i would do is check the pump impellor for debris

take out filter , dry out water, remove the plastic piece on the pump inlet ( half moon shape)

you can then use a small mirror and a torch and look at the impellor

Dave

[electrofix]

have emailed it as well to make it clearer

Dave

[electrofix]

see if this helps

Dave

[electrofix]

the drain hole will be at the bottom not the top

also check the door is closing properly as a dud deal introduces moisture

Dave

[electrofix]

the water is always conensation and normally it goes down the tube onto a tray on top of the compressor and eveporates

when you defrost make sure that tube is clear

Dave

[electrofix]

on these machines the pump is used as a sensor to detect water. if the pump gives the wrong reading then the heater will not be turned on

first thing i would do is check for debris in the pump. if it has some it wont be much as it works every now and then

also check and clean the central filter. take filter and strainer out and check it

Dave

[electrofix]

unpug the 2 white connectors

plug it in and if it trip its not the heater

if it does not trip then the heater is where you look next

Dave

[electrofix]

all the black box is is a connector and unless its burnt its not faulty

suppressor is inside the steel box

had one the other day and it was the heater causing the problem

disconnect the white connectors in your pic and try it

it wont heat but if it doesnt trip it could be the heater. if heater gets wet it will cause same problem

Dave

[electrofix]

suppressor part no should be either

1883880500
or
1883880600

both should fit but the one ending 500 is the one i would look for

Dave

[electrofix]

and have you tried disconnecting the wires after the suppressor to make sure its that

Dave

[Author]

Posts