Forum Replies Created
-
Posts
-
well there are 2 identical NTC,s in the motor. they must measure the same otherwise it wont heat. since its unlikely both will fail its an easy check
Dave
can sort of see whats going on its the second winding thats making me think. cant see how that connects with the circuit
usually there are 2 windings , start and run
the run winding is across the mains but the start winding is in series with the cap just to start itDave
tilt the machine back 45 degrees against a wall or similar and climb underneath
on some machines unit wont function if brushes lose contact with armature
Dave
well if you have not done already
remove each connector and put it back twice
if the contacts are dirty it will clean them
have you tried cancel button ?
Dave
both are the same diagram. all thats added to the first on its the control circuit. control circuit closes a contactor to start motor
Dave
well can make a few guesses but that all they will be
you have a start and run cap
the start cap will be in series with the pair with the end switch. i assume by end switch you mean centrifugal switch on the motor rotor
the main wiring red brown pair ewill be connected directly to the mains
after that it gets a bit i dont know
have you got the wiring diag they sent you
might give me a clue
Dave
press and hold start button as if your cancelling the programme
see if that does anything
the selector or the wires too it could be faulty
Davethe wires inside the door are common to go but its not a cheap repair
also getting the door off is fun, look up the owners manual
1st you lock the trolleys then there is a ring either side you have to use a small screw driver to unlockThen it lifts off
Dave
