Forum Replies Created
-
Posts
-
Re: Siemens SE26T251GB/04 – Not filling
go here
http://www.siemens-home.bsh-group.com/u … pare-parts
put in your Enr and search proceed into spare parts tab and select drawring page 4
item on drawring 0410 on left side is where machine measures water intake. it has a habit if becoming clogged over the years
strip and clean it and the hose leading to the sump and see what happens
Dave
Re: Hotpoint FDEB31010G Heater Connections Query See Photos
there will be a built in overheat stat (one shot device) thats failed
Dave
Re: Dishwasher heater control
you can go here and look up parts
http://www.bosch-home.co.uk/store/spareparts/search
are you sure it is heating slightly ? is it plumbed to hot water making you think its heating
first thing I would check is the timer as the heater relay solder joint has a habit of failing. cheap easy fix if that’s what it is
Dave
Re: zanussi cooker
since both small rings are the same swop them. if fault moves its the ring
cant get a wiring diag but above should tell you if its the switch or ring
Dave
Re: Hoover DYN7164D Filling at end of cycle
and no one had noticed the noise it was making for weeks before failure lol
get it all the time when you ask them they say “yes now you mention it, it did seem a bit noisy ”
Dave
Re: Smeg SUK92CMX5 Clock
if you post a clear picture of the back of the clock i should be able to figure it out
Dave
Re: SAMSUNG washer 3E error
well it will be a 3 phase motor and i assume the electronics will be looking for a drum speed thats its not attaining
does the motor seem to hesitate when it starts ?
if yes may only be getting 2 phases instead of 3 so could also be the board
Dave
Re: Miele G4203i – wet inside after program finished
if it had a drain problem it would go into fault mode as the unit detects whether the water has drained also you would be left with all the water in the bottom
did you check the programme you used got hot as a combination of heat and the action of the rinse aid helps to dry the dishes
Dave
Re: electrolux ER8817C thermostat
gen part number 205 47 04-55 / 2
both Qualtex and connect dont list any alternative but it looks to have a very long capillary tube from the picture
gen is £5 dearer at connect can buy it retail for the 60 more
http://shop.zanussi.co.uk/product/20547 … +K57-P2060
Dave
Re: Hoover DYN7164D Filling at end of cycle
check its plumbed to cold. some Beko;s do that when they are plumbed to hot
Dave
Re: Smeg SUK92CMX5 Clock
if its a basic clock it can be bypassed by bridging the correct wires at the back
Dave
Re: whirlpool adp4601 851150415850
got that wrong new motor is higher ohms therefore lower power.
does not make sense to me either
Dave
Re: Baumatic BTD1 extra wire
one reason I charge to go out so I get paid something.
his m8 has one for sale? but it would he would be very lucky if it was integrated
Dave
Re: ARZ853H control board circuit.
cant see why they would have a bridge rec feeding a relay coil unless there is a separate supply just for it , but that would mean using opto isolators from the main circuit
more likely is the power supply to the whole board faulty and below voltageDave
Re: Baumatic BTD1 extra wire
if you have the white knight model number off the plate go here
http://www.whiteknightspares.co.uk/service-manuals/
Dave
