Forum Replies Created
-
Posts
-
Re: whirlpool S20 FSS10-A/G problem
have you checked for ice build up in the rear of the freezer. these units as advertised as frost free but I see them as frost resistant
if your not sure do a complete defrost doors open power off 48hoursDave
Re: ARZ853H control board circuit.
circuit diagram of the whole unit could maybe be obtained but you want the circuit diagram of the pcb not a hope
post pictures of both sides of the board and i will see if there is anything i can spot. please be careful they are in focus as i will have to enlarge them to look around
Dave
Re: whirlpool adp4601 851150415850
not sure what info you have but have pm’ed you all i can find
Dave
Re: Electrolux ESOMSS cooling fan will not stop
seems to be controlled by a stat mounted by the grill terminal
sent you a pm that may help
page 31 item 2
Dave
Re: ISE10 drains after a few minutes, then turns off.
have not got access to tech on this machine but it sounds like a fault is occurring and the machine aborts the programme
I would check motor brushes first if this unit has them
Dave
Re: Falcon 111 GEO – T keeps tripping.
ask the site shop first. where possible fit gen elements but if there is an Irca alternative they are normally ok
Dave
Re: Falcon 111 GEO – T keeps tripping.
Grice86 wrote:When the engineer tested it, it was showing that the other elements where ok though? Or is it possible for them to trip when turning the temperature up
in a word yes
also depends how he tested them. with a 9volt multimeter or a 500v insulation tester
miltimeters are a good guide but cant rely on them entirely for earth faults
Dave
Re: Falcon 111 GEO – T keeps tripping.
HAS wrote:hive had one of these and it turned out to be the bottom element that had low insulation
its quite common for lower element to fail. I am assume its because most people use fan option and not the convection oven so lower element absorbs moisture through lack of use
Dave
Re: Falcon 111 GEO – T keeps tripping.
you can be reasonably confident circuit is ok
so go with disconnect elements and take it from there.
Dave
Re: AEG dishwasher only heating a little
not all appliances fault out on no heat
heater is as pictured. positioned underneath. hose comes out of main pump one branch goes to the heater.
disconnect wires, measure with multimeter on ohms range, should be around 25 ohms
Dave
Re: AEG dishwasher only heating a little
I would check the heater first. you can get small temp rises from the water being pumped around.
if the heater has gone its the easiest to diagnose. disconnect and check it with a multimeterDave
Re: In search of the fourth cord
Martin is busy again
fairly certain I am right from the symptoms and they did post the pnc at the top but martin missed it
now he is sending them off looking for a fill fault when it looks like a board failureDave
Re: Zanussi aquacycle 1200
unfortunately I think martin may have got things a bit wrong. I also saw you had already posted the PNC number in your first post
it is true fault E11 is a fill fault but it would not present with 11 flashes it would present with 1 flash for error 1?
your fault on the other hand is one of 3 faults EB1 EB2 or EB3 which flashes 11 times for B. ie error B?
so I stand by my previous post unless someone else has another ideaDave
