Forum Replies Created
-
AuthorPosts
-
November 12, 2016 at 5:46 pm in reply to: Programme lights on NEFF S5453 dishwasher not coming on #442726
electrofix
ModeratorRe: Programme lights on NEFF S5453 dishwasher not coming on
in the door
you also have to make sure it has not gone bang for any other reason. if another component has failed then if you put a new one in that will fail as well. From what Martin says its probably unlikely but you cant rule it out till you have checked
if you buy a new one you will get a 2 year warranty and Neff and bosh are the same units so whichever is cheaper
Dave
electrofix
ModeratorRe: Hotpoint WMXTF742P tripping
How?
you are looking for an earth fault as I assume its blowing the RCD and not the MCB and the main board is well insulated in a plastic box.
Dave
November 12, 2016 at 4:51 pm in reply to: Programme lights on NEFF S5453 dishwasher not coming on #442724electrofix
ModeratorRe: Programme lights on NEFF S5453 dishwasher not coming on
looks like part number 497484 Neff price £110
look here http://www.neff.co.uk/store/spare-parts
put in your Enr number for complete parts breakdown
dave
electrofix
ModeratorRe: Tecnik TKL9060 Washing Machine
the most common cause of no spin is out of balance loads.
have you tried a fresh load to see if it would spin that ?
Dave
November 12, 2016 at 4:13 pm in reply to: Programme lights on NEFF S5453 dishwasher not coming on #442719electrofix
ModeratorRe: Programme lights on NEFF S5453 dishwasher not coming on
does not sound good with the burn smell
but
when the pump impellor runs all the time the first check is to make sure the base of the machine has not flooded. the machine is fitted with a float in the base that activates the pump in the event of a leak
as I say its unlikely as I suspect the timer may have blown as normally all the lights come on but the pump runs and the prog wont start
Dave
electrofix
ModeratorRe: 1 oven on New world 90dfdo range not functioning
replace only cannot be repaired
if you access and look at it ( do not remove wires ) you should be able to see faulty contact and confirm diagnosis
dave
electrofix
ModeratorRe: Stoves 720EF control panel
the clock is probably obsolete but it should be possible to isolate the clock so the oven will work without it by joining the correct wires inside the cooker
Dave
electrofix
ModeratorRe: 1 oven on New world 90dfdo range not functioning
check clock or multi function switch first
Dave
electrofix
ModeratorRe: Hotpoint WMXTF742P tripping
Faulty socket ?
mains suppressor?at a 90 min wash would expect it to be heating at this point therefore its pulling power and things get warm and more likely to have an earth fault
Dave
electrofix
ModeratorRe: qualtex twin tub xp870-81885
have found where its made and your model is slightly wrong
Dave
electrofix
ModeratorRe: Neff dishwasher cover
its special tool time but it looks hexagonal
so it must be a big allen keyDave
electrofix
ModeratorRe: Neff dishwasher cover
oh i see what you mean now
part unlocks by turning anti clockwise so i use 3 screwdrivers
place 2 through 2 opposite hole ( not too deep. then holding the ends of the drivers with one hand use the third one as a lever to turn the unit to unlock it. dont just force it but gently apply pressure on and off till it gives
its a bit of a juggling act but had done it a few times. have attached a graphic to give you the idea but its upside down so you just use it as a guide
thanks to qualtex for the pic
hope it helps
Dave
electrofix
ModeratorRe: BEKO Fridge Freezer CDA539FW
i would guess it comes out towards you BUT
the hole marked will lock it in with a lump of plastic sticking up. there also might be another one underneath
Dave
electrofix
ModeratorRe: Replacement For Strix Simmerstat
think this will help with the wiring
http://www.ukwhitegoods.co.uk/downloads … wiring.pdf
Dave
electrofix
ModeratorRe: Smeg SUK61 – no electric
well it sound like there is no power into the unit. you need to check the mains cable into the cooker first
dave
-
AuthorPosts
