Forum Replies Created
-
Posts
-
Re: Suppressor in Zanusi Electrolux ZWF16581W
although its possible in practice its more likely to be a board fault
Dave
Re: Hoover Logic 1300
is showing in production around 1993
well built machines but as with most tech they have had their day and most parts are well obsolete
have not reconned one of these for over 10 years
Dave
Re: How to remove filter screen at back of dryer
have not got the model of your dryer but I think all the filters are the same so looked up one at random
part number 09012055
think it just might be still available
if you post the model of your machine can check part number
Dave
Re: How to remove filter screen at back of dryer
should turn one third turn and come off
push slightly, turn one third and it should pull off
if it does not it could mean the boss at the back of the drum has somehow worked loose and is going round as well
Dave
Re: Jockey pulley burning out on Hotpoint/Indesit dryers
are you fitting gen wheels had problems with Qualtex pattern so wont use it now
Dave
Re: Hotpoint WMXTF742P tripping
it would blow the fuse or the mcb not the rcd
not to mention blowing a hole in the board
daveRe: Hotpoint Fridge/Freezer Module PCB control units.
I don’t do a lot of fridges etc but I cant think why you would need to do what you are describing
why? what fault do you hope to cure by doing this ?
Dave
Re: PCB type thermostat compatibility ?
you have only changed the pcb but the temp is controlled by an NTC which in most fridges is foamed into the case in manufacture. to change it may well involve digging a hole in the insulation and refilling it with foam after. It also need knowledge of where it is to get the new one in the right place
not a job I want to doDave
Re: zanussi w1042w erratic behaviour
I have sent you a private message with a bit more info.
component may not be the problem but is liklely given age and symptoms. its not expensive so its always worth a try
hope it helps
Dave
Re: zanussi w1042w erratic behaviour
when these machines get older the power supply feeding the electronics on the timer fails. It does not just go but it get lower with time just like a battery running down. one of the thing you notice is the machine fails to spin, it tries but does not get to high speed. cheap easy fix if you can solder and source electronic components. if you cant contact QER they can fix it
Dave
Re: Hotpoint EW81G Cooker Hob Wiring Diagram
http://www.ukwhitegoods.co.uk/downloads … wiring.pdf
will this help
Dave
Re: John Lewis JLAFFS20074 Controle Module
looked this one up
no service manual but have pm’ed you the part manual
hope it helps
dave
