[electrofix]

if you type freezer door alarm into amazon you may get a louder one

Dave

[electrofix]

It will be vestel
not a problem i have had but I wonder if the condensor is blocked

service manuals on aswo if you have access

Dave

[electrofix]

whatever the fault is, and i suspect it may be the ignition module, As Kai said it can only be repaired by a gas safe enginneer as the hob would have to be removed from the gas supply

also you say that one ring is clicking but normally ignition units spark all the rings at the same time. it would be unusual to have seperate spark generators

I cant check as Bosch spares site does not seem to work at the moment

Dave

[electrofix]

since over the years small earth leaks on elements cause all sorts of faults have you tried disconnecting elements to see what happens ?

Dave

[electrofix]

well you can forget that it will be a sealed drum assembly and cannot be taken apart

and a little bit of play in the drum might make a noise but it wont make it bounce

Dave

[electrofix]

you have missed nothing as far as i can see
thats an out of balance load and some loads will do that. have you tried putting more washing in ?

Dave

[electrofix]

its in the documents along with the model along with part diagrams etc

you will need the long serial no and it takes a bit of trial and error to enter that to find thew correct model

Dave

[electrofix]

washingmachinewoman wrote:They say they inherited the machine, I assume therefore they don’t have access to the Hotpoint parts guarantee.

I see that throws a spanner in it

problem we have as always is we dont know the cause

think as a start you could swop the pressure sw as they are less than £20

Dave

[electrofix]

service manuals for these on Aswo

Dave

[electrofix]

possibly not

pictures on Qualtex and connect show 120 on the side whereas Aswo spring shows 112

also the spring on the gen one looks like its stretched more

Qualtex list them as well and have stock and are slighly cheaper

Dave

[electrofix]

problem is if it does not cure it

if its only a couple of years old suggest customer claims on part guarentee which will be cheaper if the board has gone as the board is about the same as Hotpoints labour charge. Board may just need a re – programme which we cant do without spending out on gear we wont use often

Dave

[electrofix]

dont think pressure system as no error codes

wiring maybe but still no error

earth faults is another long shot maybe

and if its the board unless you can programme boards its a hotpoint job

Dave

[electrofix]

its part of the transit brackets

not needed now

Dave

[electrofix]

with a short programme and if its just trickling out it may not have time to refill if water drops

was thinking the short programme might be less load but just checked and its a full load programme

if it was the pressure sw problem i would expect the load water to get higher and higher throughout the wash so is the water load overfilling on the faulty programmes ?

Dave

[electrofix]

you could try taking it out and looking at the bearings add a bit of light oil etc

other than that they are £69.22 from Neff

Dave

[Author]

Posts