Forum Replies Created
-
Posts
-
Re: Beko WMB91442LW
have pm’ed you a bit of info but there are 2 machines with the same model so there will be differences
7110841400 & 7110843500
Dave
Re: Bosch door handle
I would say no
qualtex stock them both and I cant see them doing this if they match
from the sketchy pictures looks like the curve on the handles are different
Dave
Re: Zanussi ZRB324NXO (925993048)
lux shows it as a Chinese built unit they also list a mod kit to stop icing up
have you checked for ice build up at the back as they say frost free but ice can still build up
if you have not checked suggest client turns unit off with doors open for 2 days and see what happens from there
Dave
Re: HJA 8703
if this is the one I think it is 2 resettable stats on the dryer heater
check the bottom of the condenser tends to block with fluff and can cause this
Dave
Re: Check water light on Bosch dishwasher
there is a contact at the side of the dishwasher that counts the water in
go to
http://www.bosch-home.co.uk/store/spareparts/searchput in your Enr and bring up the diagrams
page 4 of the breakdowns item 0405 left hand side
its either this ( most likely) a broken wire to this unit or a faulty in the board
Dave
Re: Whirlpool Heavy Duty Series 8 tumble dryer which has sto
typical modern installation we were taught to twist the cable so it did not compress i find so many joints like this.
none of mine ever failDave
Re: Spray Arms not turning at all on Lamona 8670 (Beko make)
first thing to check is for blocked filters, blocked arms, and has it taken in enough water
Dave
Re: Diplomat APL 3201 replacement element fitting different
https://shop.ukwhitegoods.co.uk/2040-co … an-element
Dave
Re: Whirlpool Heavy Duty Series 8 tumble dryer which has sto
well that’s wrong without a neutral it wont work
get a table lamp, take the plug off and connect the wires to your isolator. if the lamp work than neither will your drierDave
Re: Bosch D/W check water?
from my point of view you cant rule it out till you have swopped it
although from experience it normally fails on the first fill you cant rule out the fluke factor ie its intermittent and just happens to get through the first fill also on the first fill the unit will be cold
Dave
Re: Bauknecht drum stopped going round
seized drum cannot be brushes
take off belt
if drum turns prob the motor if it does not its either drum bearings or something stuck between the drums ( a few socks can jam a drum )
Dave
Re: White knight – 96AW DEAD
you may find some info here
http://www.whiteknightrange.co.uk/service-manuals/Dave
