Forum Replies Created
-
Posts
-
Re: Beko BE61FSW (single oven)
from what i can see this ovens cooling fan is switch by the rotary switch contact 2 therefore gets its live direct from mains ie no stat
can send you tech diag if you like but i would look to replace switchDave
Re: Hotpoint DWF50 failing to drain
i would not have changed drain pump till you had acertained there was power getting to it
since the pump is new then it can be only 2 things1 broken wire between the programmer and the pump (check bottom of door where wire come through)
2 faulty programmerDave
Re: Hotpoint FFA70P – Fridge Freezer – compressor on/off
my first thought are look a pcb for power supply
if its a capacitor normally either 1uf or 1.5 uf change that
look in section simple pcb repair tips for more info
Dave
Re: Bosch SGV4313gb/17 Wiring diagram
on this dishwasher the problem will be the flood switch mounted front left hand side. you will find a plastic float and a plastic arm going to a microswitch
sound like float may have moved and jammed
Dave
Re: TDS……ARGH!!!!!
have no probs with xp or 7 works treat
i use the iso file of the disk and run it using Daemon Tools Lite ( from file hippo ) ( creates virtual cd drive )
that enables me to run the disk on 4 systems at the same time also since all files are on the hard drive access is very fast
Dave
Re: one for all the super smart sparkies on here
AMS wrote:My personal take on this is that someone has quite clearly bought the wrong appliances for that particular installation and the correct ones need to be obtained. End of. It’s not as if a couple of grand here and there is going to make much difference anyway. Whilst an interesting exercise in electrical theory, I would just bat it right back to them.
Just my two penn’orth….Dave
totally agree with that point. the ship problem stems from where they are made. they are built with whatever domestic supply is available and this has a knock on effect for all electrical products during the life of the ship.
get these probs every now and again. customers who import electrical product without asking first and then suffer the conseqencesDave
Re: one for all the super smart sparkies on here
you can change voltage but not frequency without using electronics
have had a lot of ships using 60hz and the 50hz wont run not sure if its the same the other way round.
the motors will run slower ie if there doing 600rpm on 60 hz they will only do 500 rpm on 50hz
also the motor resistance will change with the frequency so motors will draw more current and may overheathope it helps
Dave
Re: Miele W827 w/m programme problems
visual but use a large manifying glass or 2 pairs of glasses even a jewelers eyeglass
you looking for cracks in the solder and some of then can be hard to see
if your unsure solder it to make sureDave
Re: Miele W827 w/m programme problems
did you inspect all the joints on the pcb relays for signs of dry joint. it seems to have the makings of a now you see it now you dont type of fault
Dave
Re: Miele W827 w/m programme problems
my theory is they could be making sometimes but not others + sparking upsetting electronics
anyway its worth checking
Dave
Re: WMA 34 PCB Damage
you could try describing the fault or join one of the online picture host sites like photobucket then post the link
Dave
