Forum Replies Created
-
Posts
-
Re: Indesit WIXE127 with failed bearings
as far as i can see the answer is yes sealed tubs
retail cost on the part shows at around £150 as a repair its a no go
as for the panel prices since the tubs go a lot i would think refurbishers would have plenty of panels but i may be wrong.
The only people who may buy the is QER as they refurbish panelsDave
Re: Neff Fan Assisted Oven Tripping RCCB
without meters the fastest way of finding out is disconnection
disconnect each element in turn and see if tripping stops
DaveRe: Componant ID……
well we know its probably a resistor what i cant make out are the coloured rings this is how you will get the value
have a good look at it try to detemine the colours your looking for
black, brown, red,orange ,yellow,green,blue violet grey white
then put them here
http://www.csgnetwork.com/resistcolcalc.html
Dave
Re: Diplomat ABA8542 (Crosslee) Vented Tumble Dryer
i would get the manufacturer code off the back of the dryer and ring crosslee technical in Halifax they will be able to tell you which board to fit
Dave
Re: beko dw600
had a look on the beko site for clues mods etc but no joy
have you had a good look at the hinges if the right one has been bent slightly it may be putting pressure on the door and not allowing it to seal
Dave
Re: Baumatic BTD1 suddenly stopped working
this seems to be a white knight dryer in disguise
have you looked at the door
there is a probe that goes into a hole to start the dryer. these get snapped of if you catch them
also try the socket to make sure it worksDave
Re: aeg oven d8804-4m
if the element stays on then my next step would be to check the relay on the pcb for short circuit
cheap easy repair if it isDave
Re: Diplomat APL1103
europart list the gas taps but under their own par numbers
14-hy-1706 and 14-hy-1549
dave
Re: Bosch WFF2000 – motor problem
a lot of motors including bosch have a thermal cutout inside the motor which could have gone either way internal motor parts are not available
my next step would be strip the motor you may be lucky and find a broken wire that can be fixed it will also allow you to check each coil seperatly
bit of a long shot but if it fails new motor
Dave
Re: I hate smeg dw: episode #274
from what you are saying i will make one assumption. when it goes dead if you turn off and on again you can reset the prog and start again
poss answer chack for capacitor power supply on pcb
if power supply is low fault will proceed as follows
machine starts pumps and fill ok. main motor starts and 2 mins in heater relay cuts in. at this point there is not enough power to keep going and pcb crashes
worth a look
Dave
Re: John Lewis JLWD1408 not draining on delicate cycle
check the manual on some delicate cycles it stop full of water before spin to prevent creasing ( rinse hold )
Dave
Re: Bosch WFF2000 – motor problem
the six contact on a motor are as follows
2 contacts armature
2 contacts field coil
2 contact tachoyou will get a low reading on the armaure and fiel but the tacho will give a higher reading. put meter on tacho contacts and spin motor by hand if reading changes its prob ok
if all ok check pcb for signs of blown tracks
make sure its unplugged
Dave
