Forum Replies Created
-
Posts
-
It is white Knight and they have gone
you have model wrong its PRTD210
you may be lucky on ebay but some of the prices are silly
Dave
and siemans list it for £262, who are they kidding
bet its because its chrome. if you dig around bet theres a white one available somewhere its just finding what will fit thats the problem
Dave
this is a long shot
look at awso part no
#F753083Dave
FRAM7 wrote:
No doubt MIELE has still the best quality but I do not think worth the cost. They still brake!
Miele fridges are made by LeibherrDave
what makes you think the mag is faulty
your in a workshop and not at the customers
rig a lead to power up the microwave transformer. make sure door is closed and there is a bowl of water inside. turn on for a minute or so and the mag should work and heat the water. if thats ok you can say the mag and HV circuits are fine. with unit unplugged dischage in case or residual HV
if that works then you dont need a mag
Dave
well new box no leaks
the only problem i had was the new box was different in 2 ways
1 there were 3 inlets
2 the catch to stop the draw coming out was different and my customers draw would come all the way out without stoppingcould not change the draw stop but had to melt closed the other inlet with a soldering iron
all sorted
Dave
a lot of self defrosing units duct the cold air from the freezer into the fridge using the freezer fan
[USER=”125″]don[/USER] another one for you m8
Dave
got a very similar machine with the same fault. Same make
just got a new dispenser body and going to fit it tomorrow
Dave
the water is underneath not where the dishes are. you have to remove the covers and mop ity out
or very carefully and slowly tilt the unit back to 45 degrees and the water will flow onto the floorDave
its one of those times when you either take a chance and hope a new door lock cures it or give up
Dave
always difficult to say
most tripping faults are caused by the element
the microwave side can be tested easily if you want to
aswo list the board at £102 plus vat but you would have to check the price is current
you have to make the customer understand there could be other faults
as a long shot disconnect the elements and see if anything changes . on the washer dryer elements with earth fault make panel display blank never had it on a microwave , yet.
Dave
