Forum Replies Created
-
Posts
-
not a great lover of Samung either, little or no service backup and expensive parts
will ask our retail expert to chip in
[USER=”125″]don[/USER] you veiw please m8
Dave
well from my point of view Hoover is not what it used to be and now is chinese owned
see articles below
https://www.ukwhitegoods.co.uk/help/buying-advice/washing-machine/2789-washing-machine-load-sizes
Dave
most dishwashers have a float in the base where the works are. if waters gets down there it sets of an alarm and runs the pump
you need to get the water out then run it to see if it repeats. if yes you have a leak and you need to find it
Dave
ok
thats the ntc mounted on the heaterso faults can be
ntc faulty replace heater
wiring broken between ntc and board
board faulty
the next step would be to locate the ntc and measure. it should measure 19.5 K ohms at 20 degrees C
if it is out of spec you will need a new heater. this should be the one but you need to check with the shop, by sending in your serial no
https://shop.ukwhitegoods.co.uk/32031612-tumble-dryer-heater-assembly
Davepossibly
look for a 7 leg integrated circuit and a low ohm large resistor
would need to dee pics of the board to point you in right direction
Dave
what i think is poss going on is the board power supply fails
am i right in thinking the whole board is dead, ie no lights at all when it fails ?
Dave
