Forum Replies Created
-
Posts
-
If its freezing the salad draws take the rear assembly off in fridge and make a new foam gasket and reassemble
I use the faithful vauxhall combo bought second hand from dealer with a warranty and head gasket goes within warranty.As fuel consumption goes 50 mile to a gallon on diesel not bad compared with belingos and kangeroos…..espicially as the combo is 7 years old and has done 126K…..the next will be the combo with side door.
The printed circuit board has been modified.
When an engineer is called via mfi the pcb has been requested to be returned due to problems which happens at the age of yours.
Very rarly will you have a compressor failure on your age but the new ones are different with everyone being a compressor.
could be a refrigerant blockage or insualtion failure as its a ocean brandt in a skirt.
If its the thermostat it woulf freeze everything not just the salad draws.
its the pcb at that age mfi are requesting when an engineer fits one the old one has to nbe returned as they have changed the design.
pm if you require a partas i hold these instock.
bought by glen dimplex i used to repair a burco tumble drier made in the 1950s funny we still had parts in stock for them at least she used them up
BELEIVE f4 IS FREEZER EVAPORATER SENSOR.
Saying that i have replaced these so many times on the same appliance even changed main pcb and the fault code still comes up
I think the best one was when i went to fit a new cooker.
You think ah cooker switch so you turn it off.
As you had to be a stick insect to get around back of cooker i decide pliers cut the 6mm cable and with that an almighty bang i even managed to blown electricity board fuse. Then found out oap diy installer had wired it in to a unfused spur not the cooker outlet so it was wired into ring main.
Now I check dead is dead.
could be pcb or compressor.
turn both knobs onto off position and turn off at wall.
count to 10 then turn on at wall and then turn both knobs on.
If it comes on see how it goes if not put your details into repair@ for an engineer finder.
Because trheir chinese crap….
It seems that either the dooe seal is wrongly made or the liner is at fault.
My way of stopping it is putting half a tube of silicon sealant in the gully that the seal fits into push the seal into it.
And pray if it comes back a new door and seal will be required.
I have not had any come back yet not even the showroom model in currys i did it to.
could be evaporater cover failing causing fan motor to slow down but at the same time it bleeds through the polystyrene insulation and freezs up water tank in fridge.
