Forum Replies Created
-
Posts
-
Re: whirpool ADG642
thanks chris can you get at it from the front as i think it is a intergrated fasetester.
Re: whirpool ADG642
is there no one around to help have to check it out with in the next 20 min . thanks fasetester
Re: whirpool ADG642
any help guys would a blockage in the pipe work cause this fault. or in the iwms any whirpool experts or penguin you have a good all around experience. thanks fasetester.
Re: whirpool ADG642
hi guys owi failure how do you test it. and where in the dishwasher can you find it. is it in the sump can it be cleaned . and can you get at it from the front behind the kick board. dirty lens does it have eye that gets a signal . or control board defective where is the control board on this dishwasher and does this dishwasher have the asko pump as he said some thing about a rattling when it was going . thanks for any help as i have to look at it before 12 noon on tuesday. fasetester 😳
Re: whirpool ADG642
thanks lerch for your reply what is the problum what should i be checking thanks fasetester.
Re: AEG D4100M OVEN
hi simon is there a cooling fan control on this oven did you check it. that keep the front control panel cool if it is burnt looking that could be your problum fasetester.
Re: servis
Penguin45 wrote:If it’s got a double cold valve, it won’t have the actuators. When present, they are on the soapbox top.
Chris.
thanks chris for clearing that up. what would you think was wrong with this machine should the board show any kind of damage. is there any way of testing these boards thanks all for your help fasetester
Re: servis
Penguin45 wrote:The original set-up used a steerable jet in the soap box, which was operated by a connecting rod to a lever tracking a cam on the front of the timer.
The current fully digital machines have two actuators on top of the soap box, not unlike the red dishwasher solenoids. They can operate singley or together to operate the jet.
The double valve works as a cross over on top of the box – the hose entering from the left fills the right compartment, the one from the right fills the left compartment. If both valves are on together, the flow meets in the middle and diverts to the centre compartment. Bosch have been doing this for years. If the roof of the soapbox becomes clagged up, this won’t work…….
Chris.
chris this machine has a double valve. see these actuators are the on top of the soapbox or under the top of the sopbox or does this machine not have them. thanks fasetester 😳
Re: servis
thanks tim for your reply when you select a program the pump should not run first. or try and run it should bring in the water. is there any way to reset this machine. when empying machine by lowering hose you can hear the pressure switch click. when the tub is empyed fasetester 😕
Re: servis
hi guys went to see machine checked valves seem ok. removed hoses and blew down pipes going to brawer. when machine is put on any cycle the pump would try and kick in but just give a jolt. removed filter all blocked up. cleaned filter still the same removed hoses going to the pump plus took pump off and checked nothing blocking it. then it would start to fill when got to the level would not stop checked pressure system nothing blocking it . then you could here the pump try to kick in. any idea what the problum would be. you could here a relay clicking for sec on control card when the pump was trying to start. the model is S/N20050500556
Re: service
thanks robinson for the reply. do you mean you blow down the pipe from the valves. what is a hile up inside the disp and what are actvators and how do the work. and if poped out can the be put back in thanks fasetester 😕
Re: bendix dishwasher
thanks guys for the information if the dishwasher stops filling again only cure is a new (IWMS) thanks fasetester.
