[fasetester]

Re: proline dryer

thanks guys for all the help you were righ wilf about the swear box. and mad max using the old belt does help this is the way i went about it. took out one screw on the motor jammed two screwdrivers under the motor. then used the old belt as a tool to pull the belt on to the motor pulley. removed screw drivers put in screw might help some one else to stay sane lol rebuilt tested tumbled one way then the other put on lid job done. had to call back the dryer was running making a scraping noise when checked it was loaded like a cement mixer would over loading cause it to make a scraping sound thanks fasetester 🙂

[fasetester]

Re: proline dryer

does the front panel come off the dryer to get the belt on or slip it over the back thanks fasetester 🙂

[fasetester]

Re: proline dryer

hi guy any one of the 16 engineers on line have any infomation thanks fasetester 🙂

[fasetester]

Re: whirpool dryer

whirpool dryer awz 3303 857533015031 how do you get at the start switch is it cliped in does the front timer panel come off does the timer dial pull off thanks fasetester 🙂

[fasetester]

Re: bosch dishwasher

so the solenoide and aquastop is inside the gray cover martin instead of at the back of the dishwasher how does it work as there is no electrical connection and how can the be tested or are the a sealed unit thanks fasetester.

[fasetester]

Re: bosch dishwasher

kept saying error cornwell can not send message how do i do away with all the post bar one fasetester.

[fasetester]

Re: bosch dishwasher

thanks martin and super fix for trying to help i know its not easy with out the enr number . deltra i did disconnect the water hose under the sink there is no connection at the back the hose goes in throught the back then connect to the the impellor jug. from their a blue hose is connected to the iwms deltra what is the gray box for on the main water feed under the sink it looks like a motorised valve on a heating system and what does it do thanks fasetester.

[fasetester]

Re: bosch dishwasher

martin wont be able to get the ern number i know i should have taken the model no ect down. by the time i got the dishwasher out pipes in behind back of unit then the main water feed jammed up the back with that big gray box. the only time i saw one of these boxes what are the one way valves or what. on hobart commercial dishwashers when the owner say smoke the did not want to repair it. i was looking the info for my own knowledge for again. are these part not common to a lot of dishwashers thanks fasetester 🙂

[fasetester]

Re: bosch dishwasher

hi guys any bosch experts what do you think. the mushroom float how does it come out. and the timer motor that goes into the in line heater box how does it work and what does it do can it cause the dishwasher not to fill. what is the gray box for just before the connection to the shut off valve under the sink the hose goes from their to a little round box it is like a acostop. with a thin wire plug going to it what does it do and what kind of problums do the cause and then from the other side of acostop blue hose to the iwms i think thanks fasetester.

[fasetester]

Re: bosch dishwasher

i know i should have looked at the number i got was model or type SL15JIB dont know if it is right or not from the info martin could you say why the beast would not bring in water . fasetester.

[fasetester]

Re: hotpoint leaking

thanks jim and alan did not take the front out of the tub. can you tell if the seal is faulty. where would the 2 extra clip go does their not need to be a ridge for the clips to clip over. if the tub had a hole in the lip is their any thing which would seal it thanks fasetester.

[fasetester]

Re: hobart

thanks for your reply john does a lot of companys not work that way now extra pressure. as well as doing your work you would think the would trust their engineers . fasetester. 🙁

[fasetester]

Re: You’ve just got to laugh

hi martin where did you get the engineer with the tool box he does a far bit of walking 🙂 fasetester.

[fasetester]

Re: whirpool ADG642

is it a fault in diaphragm switch in the sump that bring the pump in after it fills. it only started filling after i removed the fill hose and reconnected it again. then when it pumped out some times would not fill unless the button was held in beside the flashing green light. the button did not feel right as if it was pushed in two far. after checking it for blockages i was going to check the panel the owner said the did not want it checked out any further. then you get ear ake from the woman for it not going then the man said he did not want it checked any further the stand and watch every move you make and moan hope it wont cost much 😡 😡 😡 fasetester.

[fasetester]

Re: whirpool ADG642

went to repair the dishwasher chris it something like the jackson. checked diaphragm switch cleaned it would fill ok then it would pump out washer pump did not seem to be going. could not find any blockages there is a circuit board flow meter at the bottom of the iwms removed and cleaned and checked connections dont think it was blocked was clear no crud what would cause it to fill and then bring the pump in before it started to wash. if there is no blockages. there does not seem to be the usal anti flood what is the long rubber tail like thing that is on the front plate for. it has a dark brown front thanks fasetester.

[Author]

Posts