Forum Replies Created
-
Posts
-
Re: Miele Dishwasher G686G
had this problem a few weeks ago on a different model .the pressure switch should switch over to the motor if it doesnt you can get this fault or if the wash pump is blocked.i had to change the pressure switch.see link below
Goodluck
http://www.ukwhitegoods.co.uk/modules.p … highlight=Re: Samsung J845 wont spin. shows ‘UE’ fault
it probably wont work with 1 towel as it will be unbalanced.try with nothing in it.
Re: Faulty Bosch SGI 5322 Dishwasher
might only be a blocked hose .get someone to look at it if your not confident enough to look yourself.
Re: Hotpoint mistral plus 8596A fridge temp problem Help Ple
Do a search for mistral and you will find the answer or check the top of the refrigeration help forum
Re: Whirlpool ADP5966 F7 fault
check the flowmeter on side of fill chamber usually bad contact on it power off first!
Re: whirlpool dishwasher 7 flashes
reed switch and soldering iron a lot cheaper .usually it is just bad contact but you will have to replace reed switch now obviously.
Re: Neff S4453N0GB/13 no water going in
there should be a 2 core black wire from the aquastop into machine follow this and there should be a connector where it finishes.disconnect it and check resistance.unplug first of course!
Re: Neff S4453N0GB/13 no water going in
Check the resistance through coil first as Penguin suggested earlier!should be 3.6ish k.correct me if i am wrong. ❓
Re: Neff S4453N0GB/13 no water going in
gurgling is the pump at start of cycle.this is normal.next it should start taking in the water. is there an aquastop on that d/w this would be where you screw on to the water mains ?if not it may be time for an engineer there should be loads to choose from in Kildare .not sure what neff themselves charge but might be best bet as the part may be still under warranty.
good luck and let us know how you get on.
just looked at valve and it is an aqua stop.it might be worth a punt and replace this .Re: Neff S4453N0GB/13 no water going in
could well be but may be worth another look if he is not used to these m/c he may be missing something .it is usually some other comonent that is failing.
when you knock m/c on does it pump out first.
check all filters /hoses to sump
what end of country are you in?
