Forum Replies Created
-
Posts
-
Re: Indesit To Close Hotpoint Factory In Bodelwydden?
It started back in December 2007 http://www.ukwhitegoods.co.uk/modules.p … =0&thold=0
Greg
Re: Removed Thread
Yea. last night I saw it 😕
It may have had the word cricket in it and Jim couldn’t resist 😆Greg
Re: Whirlpool sixth sense fault code????
Ok, without model number lets use say AWO/D 5516 which is a 6th sense, F12 would be a heating circuit fault 😀
Greg
Re: Whirlpool sixth sense fault code????
Be better if you get the numbers below the barcode TBH 😉
Greg
Re: Siemens WXLS140GB Bearing replacement.
You could ask Siemens direct 😉 😆
We do sell genuine parts aswell 😀
Its hard to say how difficult without knowing your ability 😕
It can be quite difficult and will require the tank removing completely from the casing before anything else.
You will require new front tank and rear tank (bearings do come seperate if you want to knock the old ones out and re-use the rear tank) halves and seal and new shock absorbers too. Depending on how bad the damage to bearings are you may need a new drum also 😯Hope that helps a bit
Greg
Re: Fault Code Guide
Indeed, I reckon a typo/misinfo 😉
Should read WFL, will send you WFF2000 fault code Martin/Greg
Re: DIPLOMAT ADP8322 – 6 Flashes and Pause
Hi 6 flashes is pointing to a fill problem ie – Cannot fill in designated time.
This can faulty fill valve, kinked fill hose, clogged mesh filter in fill hose, low water pressure feeding appliance etc 😉Greg
Re: Spam
I think Ks found him a erm home 😀
As Jim spotted. IPs same as that little tinker in Luton 😆Greg
Re: bosch WFB2000 spin problems
Penguin45 wrote:Intermittant spin is often the Eaton timer.
Wasnt that a Jam single :duck: 😀
Greg
