Forum Replies Created
-
Posts
-
Re: AEG Cooker Prod 948519007 – Fan Motor Pt. No.
Hi
Try
3115211017 fan motor kit
3740754217 ring back left
Geoff
Re: Cooker oven thermostat – Stoves 800DF STAY AWAY !!
Did one myself earlier this year and it was a kit of 2 thermostats, 2 selectors and wiring plus knobs.
It does take about hour and worth spending a bit of time reading the instructions before you go.
The original thermostats are not available.
Geoff
Re: Hotpoint BHWD129
Hi Garn
3 different versions on Pathfinder but lucky all use same handle
C00259035
Geoff
Re: Hotpoint WMD960 wiring
Hi
Will try again upper module again but would appricate wiring diagram if any one has it
Geoff
Re: Invensys MPV01SV regulator
Hi
yes they are all about £10/11 pounds plus vat plus delivery but the diamond is only about £6/7 if there is a suitable replacement.
Customers seem to wait until there are 3/4 gone before calling and that gives them a heafty bill.
Just hoping that someone have been down this avenue before
Geoff
Re: Continuous Clicking From Main Oven
Hi
When the oven flame lights the flame itself earths the electrode stopping it sparking.
I would suggest that you check that the metal end of the electrode is in the flame when it is on full flame and when the flame dies down. Use a pair of pliers to adjsut bracket
Do not crack/damage the surround to the electrode as this will make it uselessGeoff
Re: LEISURE COOKMASTER CM101 NO SPARK
Basic circuit would be power from timer relay to microswitch on thermostat to ignition unit.
Normally when you turn the thermostat it operates a microswitch which is located on the shaft of the thermostat. this allows power from the timer to reach the ignition unit and gas valve ( if fitted)
Check clock not on auto and there is power from it would be the fitrst thing to doHope this helps
Geoff
Re: Beko Slimline D/W D2731 FW
Have sent exploded diagram for you.
White paste used would be something like heat sink compound?
Geoff
Re: Polar commercial larder
Hi
Is this a digital display about 3inches wide and 1 inch tall?
I have been using a company called Catering Parts for my commercial stuff (also has items listed on ebay) tel 01924872972 Duncan is the man to ask for
HTH
Geoff
Re: Hotpoint WMA34p manual
Surprising how things change when you get there.
Unit does start and fills with water. But wait a minute the motor ramps up into spin instead of tumble.
Wiring rubbed on weight and the taco wiring worn through.
Repaired and away it went.
geoff
Re: Hotpoint WMA34p manual
hi
from the conversation I had with the lady nothing happens.
Perhaps it is going to be the old door lock or motor brushes problem??
Geoff
