Forum Replies Created
-
Posts
-
Re: Miele W460
Thanks for reply.
Found pressure hose between chamber and front control panel had rubbed on plastic wiring channel.
New pipe and re routed – job done
Geoff
Re: DIF04 dishwasher wash pump.
On the indesit dif04 dish washer it would be the pump with impeller assy part number C00256525.
Reminds me of the one fitted to the whirlpool/hygena dishwashers that used to fail
Geoff
Re: The Green Mile…How Do You Avoid Death by Electrocution
Would the purchase of an RCD not be easier??
Geoff
Re: hotpoint eg900x
HI
Just a question but from my rather faded memory does the cut not operate when the temerature of the oven gets to 75c which in turn will than power the fan.Maybe the old memory box is wrong?? but worth a check
Geoff
Re: zanussi t/d tc7102w
Hi
Its usually the thermostat inside the top of the door. Held on by 2 screws bit of a fiddle
Part number 1258406014
Should read zero ohms if ok.
If this has gone check filters, condensor unit and that there is no blockage to the water tank ( may complain of some water over floor)
HTH
Geoff
Re: bosch f21 fault
try this link which is for gb 02 version
http://www.ukwhitegoods.co.uk/modules.p … =bosch+f21
But normally there is a speed reduction switch / spin speed switch
Geoff
Re: zan zwf12070w
Is the pump running at the begining of programme?
Zanussi machines will alwasy start the programme with a short pump out and the pressure switch will look for a change in water level. If this is ok it will then start to fill.
If this is ok then you will need to go into the diagnostic mode
Geoff
Re: Hotpoint WF340
Do you mean the two wires which go to the heater?
If so they fit into the six way block . there is a 4 way plug that fits into this block and next to this comes the brown wire and the last terminal in the block is the blue
If it is the mains in (but would be in a 2 pin connector?) the terminal nearest the bottem corner of module is the brown and the next one up is the blue
HTH
Geoff
Re: ZWF1270W
Hi
Is it ZWF12070 /?
I have sent you an email which I hope will help. You will need to go into service mode to check for fault code. If there is no fault code look for earth leakage on heater and motor. ( there are times that it will fault without giving code for this)
It sounds like it is detecting a fault and then carrying out safety drain.Geoff
Re: premier electrics
HI
Part of Comet is called ON Call. Looking at site this relates to the computer side of business. Logo looks simular to one on oncall.co.uk but colours are different.
Geoff
