geoff1

Forum Replies Created

Viewing 15 posts - 271 through 285 (of 409 total)
  • Author
    Posts
  • in reply to: Candy CHZE6886w #305073
    geoff1
    Participant

    Re: Candy CHZE6886w

    Thank you again chris

    Geoff

    in reply to: IKEA DWH810w #305068
    geoff1
    Participant

    Re: IKEA DWH810w

    Fantastic

    Many thanks for the quick reply

    Geoff

    in reply to: Zanussi ZSF4123 module mishap #304116
    geoff1
    Participant

    Re: Zanussi ZSF4123 module mishap

    Hi

    you have mail. Information about plug reversal is on page 34

    Geoff

    in reply to: Zanussi ZSF4123 module mishap #304114
    geoff1
    Participant

    Re: Zanussi ZSF4123 module mishap

    Hi

    I think that the power plug (Live/neutral) may be in the wrong way round.

    If you send me you email address I will send you some stuff

    Geoff

    in reply to: HP and Creda part numbers #303934
    geoff1
    Participant

    Re: HP and Creda part numbers

    Hi

    Checked the part number on the connect site and the picture that came up is the one that you are looking for.

    I would suggest that some one has it bagged wrong

    Geoff

    in reply to: HP and Creda part numbers #303927
    geoff1
    Participant

    Re: HP and Creda part numbers

    Hi

    Door seal for 37761 c00095978

    timer knob for vtd20 c00207479 (white in colour)

    Geoff

    in reply to: Whirlpool 3RLSQ8533 Top Loader #303620
    geoff1
    Participant

    Re: Whirlpool 3RLSQ8533 Top Loader

    Hi

    Thank you again for replies.

    Took of motor/gear box and checked the motor coupling which looked ok and was driving throught to gear box. also no oil had leaked out of gearbox.
    The one machine has no drive on spin and the other will no start intermitant (motor always starts up.

    Does it sound like just the clutch still??

    Geoff

    in reply to: Whirlpool 3RLSQ8533 Top Loader #303618
    geoff1
    Participant

    Re: Whirlpool 3RLSQ8533 Top Loader

    Hi

    Thank you for that – will take motor off tomorrow and check gear box etc.

    Are these prone to any particular faults on the drive system other than leaking oil?

    geoff

    in reply to: Zanussi ZWD 14270W counter weight part no. #303033
    geoff1
    Participant

    Re: Zanussi ZWD 14270W counter weight part no.

    Hi

    Weight is 379410012/7 and tub rear is 132046981/1. this is for product code 914604002/00. Care should be taken to ensure that tub is not the welded type.

    Geoff

    in reply to: New World DW60 (Stoves) #302448
    geoff1
    Participant

    Re: New World DW60 (Stoves)

    Had a good search but nothing there. Machine still working fine so customer going to let me know when it goes faulty again. Will post reply if I do get an answer

    Geoff

    in reply to: Diplomat ACA9202 #302437
    geoff1
    Participant

    Re: Diplomat ACA9202

    Fault found at mains terminal block where neutral wire have corroded somewhat. replace terminal connectors and the heat was on. Block is situated at front towards left hand side of base. No cover on it to stop water getting into it if door leaks?

    Geoff

    in reply to: New World DW60 (Stoves) #302446
    geoff1
    Participant

    Re: New World DW60 (Stoves)

    Thanks Jazz

    This uint is branded as a new world but has stoves model number and product code number on it – not sure if this is the same as the one you are talking about. Haier machines yet to be seen on these islands as yet.
    This type has a heater with pressure chamber attached. Micro switch makes to allow power to heater once motor has water up to pressure?
    Does this sound the same?
    Could not see any additional saftey cut outs? where are they located?

    Geoff

    in reply to: error codes for samsung american fridge freezers #299585
    geoff1
    Participant

    Re: error codes for samsung american fridge freezers

    Hi

    Try this link

    http://www.ukwhitegoods.co.uk/modules.p … ge&pid=209

    Geoff

    in reply to: servis tumble dryer start switch repair m2005w #299472
    geoff1
    Participant

    Re: servis tumble dryer start switch repair m2005w

    Hi

    Check the 6.2k resistor to see if it has gone open circuit. replacement can be fitted if it has

    Geoff

    in reply to: RANGEMASTER CLASSIC 110 #299389
    geoff1
    Participant

    Re: RANGEMASTER CLASSIC 110

    Hi Mike

    Thank you for having a look. I can see that this may be the one so will order and try when in. It is just that Rangemaster is mine field even with the product number.

    Geoff

Viewing 15 posts - 271 through 285 (of 409 total)