Forum Replies Created
-
Posts
-
why would u wanna buy em, most of us give them away, u only need to ask, and supply ur email adress 😉
the boards faulty, its a heater relay fault
theres several variants, depending on software version.. hot./cold fill.. heater box type
if you hate it, chuck it and buy summert proper
yep, the drum siezed and the motors carried on. and burned through the belt
its all downhill from here on in…..
yup, and its a pig of a job too
i suspect its dual fuel?
in which case, we cant advise you im afraid
its f04 … pressure switch stuck on empty
that could be the pressure switch itself, or maybe a hole in the tube leading from the pressure bottle to the switch
or of course, the dreaded pcb problem!
plug out if your checking!
the latest proline washers are..u got it…. haiers!
they dont spin either
and yes they blow up pretty quicklyThermal Spin
A thermal spin on the High Heat setting is carried at the start of the of the drying process. The load is
pre-heated to approximately 50°C by the dryer heater with normal tumble action and pump out. The
thermistor located in the wash heater will sense the load temperature and when 50°C is achieved a 5
minute Spin profile will be carried out at full spin speed.
During thermal spin the out of Balance detection will operate and maximum speed will only be
achieved depending on the out of balance condition.
On completion of the Thermal Spin, the tumble drying process will commence for the period of time
selected.
Thermal spin is NOT available when low heat is selected.thats from the manual.. but still it doesnt say why
hmm
hes a full fledged member of the fit for purpose brigade
i will get a recall, as sure as eggs are eggs
im gonna make sure i never get that job again
no
mike-in-horwich
http://ukwhitegoods.co.uk/modules.php?n … 07ab2ebaba
and it got nastier in email
http://ukwhitegoods.co.uk/modules.php?n … 07ab2ebaba
then
http://ukwhitegoods.co.uk/modules.php?n … 1910d7144a
hence me calling at his home wasnt the best scenario
it the responsible person thing
if your a trader, and your charging, then yes, as soon as you do ANY work to it, you become the responsible person
martins right, its the same reason they put bayonet hoses on cookers, so the consumer can remove and clean, and refit
this has been discussed to death before, and if anyone wants to do their own gas repair, theres nothing on gods good earth that can stop them
it is litteraly when your being paid for doing the work
got a very bad case of gout, and its doin my head in
had it a week now, and its just startin to go away
and im still working, even with a bad foot
mind u , your up early too!
