[helo_75]

F01….OFF, OFF, OFF, Flash, OFF

is a motor triac fault

usually that means the boards gone

BUT

it could be a broken wire in the motor harness and/or board plug?

experience would suggest a pcb problem, to which u need a new smart card and reader, thats subject of course to whether it has a ceset motor or an fhp motor

confused? oh you will be… just look around the forums, its littered with many weary tales of unereliable indesit electronics

and if your going to look, make sure u unplug the machine for 5 minutes before you go in

thank you, hope this helps?

[helo_75]

the heater box is the big silver unit on the top of the drum ,with the fan and heater attatched.. the condenser is the white chute that runs rom th underside of the heater box to the rear of the drum

theres two spider bolts underneath there

id make a note of the wiring if i were you

[helo_75]

well, people in here will often point u to the ise… a good machine, good value with a lengthy warranty, yet at a price

reliable at a good price? bosch everytime, stay away from the hotpoint/indesit stuff and ull be somewhere around where u need to be

motor will be around 70-80 £ so it really is a bad idea if ur not sure

[helo_75]

if you take the heater box and conenser off, then undo the 8 retaining bolts for the spider, then it will come out through the back

be very careful though, the back panel is like a big razor blade!!!

[helo_75]

sorry, but the motors goosed

its an indesit, and hopefully a lesson learned

i never put brushes in them

[helo_75]

door locks usual suspect, but id check the plug top/socket first

[helo_75]

you have some sort of restriction in the sump/pump/drain hose area

plug out if your to inspect

[helo_75]

well

its either the emitter or the reciever, they arent massively expensive, or difficult to change, so it might be a good idea to do that

hope this helps?

[helo_75]

and the fact that the drum doesnt go round?

you may as well put them on the kitchen floor and use a hairdryer

the answers no, sorry

[helo_75]

definately a timer fault

dont use it, youll blow the thermostats

theres 2 timers for that model, need the serial number to get correct one

[helo_75]

it is hard to get it so very wrong

but if you really need a wiring diagram, give me your email, and ill send it to you

[helo_75]

from the drawin i got

6 is live
3 us common to defrost heater/anticon heater/green neon
4 runs to the defrost timer/economy switch

if your not sure, give me your email addy and ill send you the manual

[helo_75]

put a new belt on it

[helo_75]

u got mail

i hope!

[helo_75]

ill do it later when im back on my laptop

welcome aboard mate… if you need anything, just ask, we’re not bad in the trade section

[Author]

Posts