[helo_75]

unusual for nothing to work, has to be said

are u sure its not just unplugged/switched off/fuse gone?

worth checking before u’ll need a spark generator, not an overly expensive repair, but youll need a corgi registered fitter to fix it for you

hope this helps

[helo_75]

don… have posted a thread on the trade forums regarding this!!

some feedback would be nice please

thanx

[helo_75]

all gas ovens have some sort of flame supervision device, be that a ffd/fsd/thermocouple

its the law, its the hobs theyre sayin have to have a supervision device, as some still dont have them

and, of course, depends whether u mean integrated oven, or a freestanding one

wont matter on an integrated one, because, obviously they dont have a hob on them

bit more info please?

[helo_75]

the dryer ntc is mounted on the heater box at the top

the ntc does the same thing as a thermostat, but is more precise

easy to change, but as jim says, could just be a broken wire

plug out if your going to take the top off to check………..

[helo_75]

to be fair, its normally brushes

[helo_75]

thats 4 1/2 months longer than they normally last

[helo_75]

fill it full of water, let it run for 10 mins, and try it again

[helo_75]

just make sure you take an eprom and board

obviously, check the sump, but its nearly always the pcb

unless, of course the pressure switch has gone, but i think ive changed maybe 1 or 2 of them as opposed to 50 – 60 pcb’s

[helo_75]

yup, they go all the time

no reason, other than theyre poor

hope this helps

[helo_75]

so, basically, you’d be happy to spend an extra, say , £1,000 to save yourself a hefty £10 – £20 a year?

and im probably well over egging the pudding

ratings , as kwatt says, are a bit of a joke, tbh

hth

[helo_75]

thats because its an el160 mr penguin

thats what he said, anyway would be better with serial number/product code

the display pcb needs to be replaced whichever way

[helo_75]

e1 on a new wave is usually the heater being slightly down to earth

do you find the machine wont spin either?

change the heater, im sure all will be fine

Power off, first.

[helo_75]

nope

most single ovens work well on a 13amp heated cable

all depends on the rating im afraid

unfortunately, we cant go greatly into details of the installation in your home, as we cant be sure what exactly we’re dealing with

if you have a cooker switch nearby, it aint so bad, if you havent, it becomes expensive, and has to be done by a qualified electrician, as you need to have a suitable fuse installed to your fuse box, wired throught to a cooker isolator unit, then wired to the cooker

not a cheap option, believe me, but needs to be done correctly for safety, and insurance purposes

more information would help.. i.e, do you have a consumer unit in the kitchen ( a cooker box, with a big red switch that says cooker on it)?

hth

[helo_75]

:rolls:

[helo_75]

i must say, its unusual one those machines needed to be regassed

id get em back, its either the gas is low, or the defrost heater in the freezer is faulty

either way, its not for the faint hearted

hth

[Author]

Posts