[helo_75]

im not sure exactly what u want?

can u be a bit more specific

[helo_75]

yes, emw will supply it all programmed up, ready

[helo_75]

u need to unblock the pump from the sounds of it

with the plug out,tilt the machine back , undo the screws, and drop the pump from underneath…then undo the pump from the back and remove whatevers in there

[helo_75]

ill read it as many times and as carefully as you like… at no point in your first post did you mention comet

if you dont want the help, fine

[helo_75]

u might wanna check that model number?

[helo_75]

c00268761

comes complete with valves, hopper top and bottom and inner drawer

[helo_75]

so they give you the service number and u never bothered

dont criticise a company youve given no contact to

[helo_75]

why dont you just go to comet and theyll do it free, especially if its only 13 months old

but let that be a lesson, ive fitted bearings in loads of those, and they fail often

[helo_75]

buy a proper washer. itll never be right.

[helo_75]

has to be a ctd?

and yes, the pumps faulty!

[helo_75]

condenser locating tabs not located properly… just make sure the red ones fully locked in place first….

[helo_75]

its a sillenium rectifier.. and i have one if you want to buy it?

[helo_75]

your dryer is a good 10 years old, it wasnt a design fault, they do fail as they get older

the modification included a new drum, front plastic baffle, seals and bearings… priced at around £90, it takes a good hour to repair

[helo_75]

fgs try the capacitor.. thats the usual scenario

[helo_75]

check the motor connections…its a well known issue that, its a neutral missing from the motor circuit that does that

[Author]

Posts