[helo_75]

as with most machines today, if the machine wasnt heating, it would stick

i must go to 4 a week where theres nothing wrong

[helo_75]

only it wouldnt lock the door if the switch wasnt there

carbon brushes, every time

[helo_75]

c00231795 is the correct stat, on both mk1 and mk2
is it dual fuel?

[helo_75]

defrost timer?

located in the little box at the back, on the left just above the compressor

take it off, advance it and watch it come to life!!

[helo_75]

well, the number on service net is C00203461
given the age of the machine, im suprised you get one of the old type numbers wilf?

[helo_75]

by chuckin it on a skip somewhere

[helo_75]

yes, its adviseable to change the top half, unless you buy the felt seal between the box and the drum… and they do need it, hotpoint placed the main pcb directly under there

cracking bit of ingenuity there

[helo_75]

its a digital switch/potentiometer

the main plug is just power, the smaller idc cable is the one used for selections .. different resistance=different program

pull your old one apart and youll see what i mean

[helo_75]

if it has the container at the bottom, take the valves off and clean them

[helo_75]

tut tut tut.

not in the public forum, youve been advised before

[helo_75]

ok e20, officially is pump failure

early washer dryers had a toc in the pump, and were notorious for getting hot, and cutting out when running without water

as for the condenser, theyre always worth taking off and cleaning

top off, 2 screws either side of top of rear half of cabinet, 1 attatching cabinet to dryer fan… two screws under the white caps, at the bottom middle of the cabinet, sometimes thers some in the rear of the back.
all 8mm screws

detatch the valve cover from the back, and it should lift out

take condenser off and clean

plug out, and be careful in there

[helo_75]

just fit a suspension kit… c00271755

the break on the right hand side, at the bottom

fitted rakes of em

[helo_75]

for picture reference, see
http://www.candmdomesticappliances.co.u … xProd=2265

[helo_75]

C00115441

is the part you require

quick email to spares@ukwhitegoods.co.uk will get you one promptly

[helo_75]

unlucky

ts part of the dispenser

theres a modified one available, but we need the exact commercial code , inside the door, 5 digits

[Author]

Posts