[hilly]

Re: Candy go482/2-80 program time

Thanks Martin, as it says in the manual any was over 60 mins will light up the 90 light, so I’m assuming its all ok and they was doubting it because of the drain fault. I’ve explained it to them and they are going to let me know of any problems, many thanks for your assistance 🙂

[hilly]

Re: Candy go482/2-80 program time

Manual not available for download ;-( can anyone confirm if this is correct for the 90 light to be on?
Cheers Paul

[hilly]

Re: Candy go482/2-80 program time

They are saying that it always takes too long and didn’t always drain, after finding the drain hose incorrectly fitted I explained that that would prolong the wash and also could stop it draining, but they are saying I didn’t use to do that with the light, I’ve told them to try it now the drain is sorted, I’ll try a and download a manual to see if it says anything in there.
Cheers

[hilly]

Re: Siemens se24t250gb/32 prog times to pot

Many thanks guys, I rang the customer and told them to put it on a 199 cycle and to just let it finish, they rang back and it has corrected its self 😉 I’ve done loads on these machines but never seen one do this, every days a school day 😉
Many thanks Paul

[hilly]

Re: Siemens se24t250gb/32 prog times to pot

Cheers Martin, I get what your saying but it works ok on the last 2 progs but when I select either one of the first 2 progs it just shows 199 think I’ll have to have another look around this one.

Thanks again, Paul

[hilly]

Re: Siemens se24t250gb/32 prog times to pot

There was a partial blockage in the sump hose, I’ve cleaned that and it’s still the same with the first 2 progs showing 199

[hilly]

Re: hotpoint WMD740P(UK)R dispenser leak

madangler1 wrote:Did you clean the hole the conditioner siphons through? . These block and it spills over. If that’s ok Iv also seen crap buildup in the jets forcing the water in the wrong direction.

I offen remove the whole thing. Split it and thoroughly clean it then refit.
Siphons are clean and I’ve replaced the top and valve but its still leaking?
Shite machines!

[hilly]

Re: Hotpoint wmf640 error codes

iadom wrote:So you have looked in the Known Error codes thread then. 😉

PS. There is no WMF640, do you mean 540?

Jim.
major fail :boops:, customer says its a 640 and apparently the customer is always right lol,
many thanks

[hilly]

Re: new style bosch dishwashers

Fitted new module, all working fi e now 😉

[hilly]

bosch w/d dryer fault

Bump

[hilly]

Siemens wm14e141gb/09

That sorted it,
many thanks.

[hilly]

Re: cda wc140 d/w heat sensor

chezza wrote:it is part of the element assy 32004301……
however, almost certainly going to be broken door wire, sensors very reliable

many thanks for this advice, it was a fractured wire in the door, the wire looked fine and tested ok but with a little tug it snapped easily.

thanks again, paul

[hilly]

cda wc140 dishwasher heat sensor

Cheers I’ll double check them 😉

[hilly]

new style bosch dishwashers

Many thanks for the replies, I’ll let you know the outcome.

[hilly]

new style bosch dishwashers

Applianceman2010 wrote:Have you checked for a dry/burnt out joint on the heater relay on the PCB?

yep, all good, thanks

[Author]

Posts