Forum Replies Created
-
Posts
-
Re: Hotpoint WT54O Flashing rinse hold light
Third light (rinse hold) flashing is F02. Motor or tacho fault.
If you are very lucky it could just be a dodgy motor plug wiring connection, I had an Indesit machine, (which this is) on Friday with same fault code that was a simple broken wire to the motor.
If the motor wiring checks out the either the motor or the main pcb could be faulty.
Could be motor brushes but they should give different symptoms, still worth checking those as well.Re: Hot point Aquarius WDL540 Fault
The resistance of any thermistor varies with temperature, for this one you should see,
@ 0°..36000 ohms
@25°..12000 ohmsNo hard and fast rules for removing the condenser, you just have to follow your nose. 😉
Re: Hot point Aquarius WDL540 Fault
Only the bottom five lights are used for error codes.
If you have used the dryer without checking or cleaning out a blocked filter as advised it will fail swiftly.
The machine runs a diagnostics check and if it finds any faults it will not run, just go into error mode.
Re: Bosch drum lifters
Hmmm, never had to change lifters on any Bosch machine before, those holes that look as though they are for fixing screws look a bit worrying. ❓
Re: Bosch drum lifters
DOH, He did give me WAB but I wrote it down as WEB then checked back with him to make sure what it was. :boops:
Re: Hot point Aquarius WDL540 Fault
You will have to remove the condenser to clean filter, a rather difficult task on an Indesit made, sealed drum machine. You can see the lint filter in the attached diagram.
Re: Hotpoint HV7L130 washing machine won’t fill / pump repai
From what I have heard from forum member johnnyj who is a franchise engineer there are times when reprogramming the module is the only option.
Re: Hotpoint HV7L130 washing machine won’t fill / pump repai
trade-technical/hotpoint-indesit-pressure-switch-reset-t69601.html
Re: Hotpoint WMA58P
Will it unlock if you switch off the power?
Could be sticking pressure switch?????
Can send you the manual if you like.
Jim.
Re: hotpoint aquarius wdal 8640
Have you checked or cleaned out the drain pump filter?
From bottom to top by number, which of the lower five right hand, VERTICAL lights are on steady?
Re: Windows 10
Install appears to have gone smoothly, very clean lines, familiar on screen tiles that are on my Windows phone. The new Edge browser does appear to be very fast, just need to change Bing to Google in it. The ‘reading view’ in Edge is very good for reading the forums, so far so good.
Re: Windows 10
The iso file downloaded from the Windows web site fairly fast but fortunately I do have Virgin Media’s 150+ MB service. 8) Just done a full system backup, will give it a go later. 🙂
It gives you the option of downloading as a straight update/install or as an iso mirror. Decided on that option as it gave me time to back up and prepare.
