Forum Replies Created
-
Posts
-
Re: Using a different suppressor
One of the three listed HERE will be fine.
Re: help please! Dishwasher little plastic box on power cord
It’s safe but illegal, that is an interference suppressor which is required by law to stop radio and TV interference.
not expensive, most common Bosch one is HERE
Re: Door interlock for indesit iwb71251
I have replaced a couple of these with the earlier type without any problems.
Re: S/H Hotpoint WM inner drum.
I’m high up in the Pennines, any trip from here to Yorkshire is all down hill in more ways than one.
Re: S/H Hotpoint WM inner drum.
Thanks Martin.
Just checked on that drum, sadly it’s collect only from Doncaster. 🙁
Re: Door interlock for indesit iwb71251
Moved to correct forum. 😉
That is the correct part number, out of stock at Masterpart,….surprise, surprise. 🙁 However I am certain that I have fitted the earlier C0085194 to these, you just have to find a couple of screws to secure it.
Main difference is delay on opening as opposed to the instant click of the solenoid type.
Re: IWDE126 error 1+2+4 flashing?
Your wife is a wise woman indeed.
Testing the NTC involves a multimeter and a bowl of hot water, it also helps to know what the ntc readings should be. The machine runs a diagnostic test at the start of any cycle and will abort to error mode if any faults are found. You should also be checking for blockages in the condenser.
Or just listen to SWMBO. 😉
Re: How to turn off end of cycle beep, Hotpoint BC20
You could try THIS if your machine has a Time Delay button.
Re: How to turn off end of cycle beep, Hotpoint BC20
You could try searching the Hotpoint site for a DWF61, long shot but it is the same basic Bosch machine, just the free standing model.
EDIT, Just had a quick look at the user manual and can’t see anything, some of the Bosch experts may have an idea.
If you look very carefully along the top edge of the stainless steel inner door you should be able to make out the original Bosch Enr number.
Just double checked and your user manual is here.Re: IWDE126 error 1+2+4 flashing?
The fan is inside the dryer assy, the ntc is mounted into the side of the dryer ducting and is a very common failure point. The condensor could also be blocked. You will have to strip down the dryer assy to examine fan, condensor and filters, after removing the mains plug of course.;)
Re: IWDE126 error 1+2+4 flashing?
Should be F13, Dryer related fault, NTC or connections, fan faulty or blocked.
Re: Indesit IDC85UK Condenser Dryer Not Filling Drawer
Is the pump working? Pour some water into the float chamber and see if it will pump it up into the water container. Check that the drain hole at the very back of the condenser chamber that leads into the float chamber is not blocked.
The pump impellors are prone to coming adrift on these pumps.
