Forum Replies Created
-
Posts
-
Re: are the modules interchangeable on the old wma hotpoints
The same pcb fits,
WMA34,5,6,7.
WMA42,4,6,8.
WMA52,4,6,7,8.
WMM39,53,59.
WMS38,39.I have never tried to fit modules from the other WMA variants myself though, I’m guessing that the microprocessor will be different so may not program correctly?
Re: Indesit IWME126UK module
If you still have that pcb then you could try the new connector harness mentioned above, don’t think it will have done any damage to the facia pcb.
Re: Indesit IWME126UK module
I would check out EMW and see if they will repair that pcb, if not it will need a new, five way connector and programming. :rolls:
Re: ISE Ci555 leaky
You need to read THIS 😉
Re: ISE Ci555 leaky
I have done that seal change quite a few times and do it without removing the whole drum from the machine.
Carefully lie it on its back and with the right tools it is possible to remove the drum front without taking the whole drum out. 😉
Re: Underwire in Bosch Avantixx 6
You got lucky, buy a lottery ticket whilst your lucks in.
Sent from my iPad using Tapatalk HDRe: ISE Ci555 leaky
THIS is the part you need. Much better to change it rather than attempt to seal the drum with adhesives or sealants given the amount of work involved in getting at it. 😉
Re: ISE Ci555 leaky
The drum seal Martin mentions is a well known cause of leaks after a few years, will be more likely to leak on hotter, longer washes.
Not an expensive part but a major strip down involved.
Re: Hotpoint FDW80 dishwasher playing dead
Sorry, my mistake, it should be C00143220. :clown:
That board is not compatible.if that picture is looking at it from the front as if it was in situ then it is ‘supposed’ to be a fill fault, possible causes are.
Inlet valve, heater Earth fault, open circuit heater.None of those would cause a display fault.
Re: ISE Ci555 leaky
NB. There is no bolt missing, there is one hole for a bolt that is not actually used or needed on this machine.;)
Sent from my iPad using Tapatalk HDRe: Hotpoint WDL520 "stopping"
BigF wrote:I had a look at the brushes when I was cleaning the filter out. I shouldn’t think they are even a third worn.
.
The only way to check them properly is to remove them from the motor, a washer dryer of this age should have worn them down by well over a third unless the machine has only been used once a week.
