Forum Replies Created
-
Posts
-
Removal of the plastic condenser is very easy once you have removed the back half of the cabinet, also quite easy to do.
Just Googled the number you gave which don’t look like Asko ones. I will PM you an email address , send me a picture of the whole motor as well if you can.
Jim.
Do your old ones look like the ones I linked to in the shop? If yes then either of those will be fine, I would go for the cheaper ones, still likely to give 5 years service at the least .
Brushes are available in our forum shop, either non gen or expensive genuine ones. https://shop.ukwhitegoods.co.uk/asko-carbon-brushes
Is the forum ‘shop’ hosted on a different server? I can access the main site quickly but clicking on the shop link just stalls.:(
Difficult to know what else to suggest for the double start problem, not something I ever encountered if door fitting was correct. As far as the leak goes all you can really do is keep an eye on it. A one off over foaming incident is a possible cause. This can be due to the type of soiling on the dishes, egg whites for instance will generate quite a lather. A spillage of rinse aid is another possible cause or traces of washing up liquid from pre washed dishes.
Worth trying without the décor panel on to eliminate that as the problem. The fact it has been like that since installation does point to that as a possible problem, a very heavy door can distort the thin metal door.
Could be something as simple as a badly fitted door decor panel preventing the door from closing correctly. Does the door appear tight to open/close?
A full bearing kit for this machine is around £55 for the parts alone. The rule is that if bearings are suspect then they should be replaced ASAP. If it has been left for several months there is a very strong possibility that it is now BER (beyond economic repair) . The damage done to the drum shaft will almost certainly be severe and removal of the old bearings could be nigh on impossible without doing serious damage to the housing.
Unfortunately I don’t know of any ex ISE agents in your area. 🙁
It is the first one I linked to Dave, they don’t show the component side sadly, just had a look through the manual and no pictures there either.
That part number, 8088613 is the correct official number but Googling it just gives the on site shop as the only hit, nothing apparently lying around on Ebay etc. 🙁
