Forum Replies Created
-
AuthorPosts
-
iadom
ModeratorRe: Hotpoint fixing spring tool
Tool is a C00284698
iadom
ModeratorRe: Hoover WDYN-855D – Not Drying
9 times out of 10 this is due to a blocked condenser.
March 14, 2018 at 10:59 am in reply to: Hotpoint Aquarius very noisy on spin, have a listen! #454324iadom
ModeratorRe: Hotpoint Aquarius very noisy on spin, have a listen!
I have in the past managed to change the odd lower weight from underneath and through the door opening, good luck.
iadom
ModeratorRe: Hotpoint WD62P motor replacement
As long as you match up the wires to the tacho on the old motor to the connections to the tacho on the new motor it will work fine without any other changes. Assuming as Dave said that no other damage has been done.
March 13, 2018 at 4:37 pm in reply to: Brand New Washer Dryer – Strange noise during drying phase #454655iadom
ModeratorRe: Brand New Washer Dryer – Strange noise during drying pha
Hmm, very strange, second complaint of this weird noise recently.
brand-new-hotpoint-bhwd129-washer-and-dryer-strange-noise-t96267.html
Same basic machine.
iadom
ModeratorRe: Hotpoint CTD00
I would say it is almost certainly faulty. Nothing else can cause those symptoms.
iadom
ModeratorRe: Smeg Oven- How do u turn the thing off
I sincerely hope the OP hasn’t had this oven switched on for over 13 years. 😆
iadom
ModeratorRe: Hotpoint CTD00
Relay pcb fitted before serial number 603270000, after that Bitron door interlock fitted instead.
iadom
ModeratorRe: Perennial question, what washing machine?
Bearing in mind of course that the Siemens is actually a Bosch. 😉
iadom
ModeratorRe: INDESIT – ALL LIGHTS FLASHING – WIDL126
Not really, more lights flashing than should be is usually a sign of pcb failure anyway. Unless every single light is flashing very rapidly.
iadom
ModeratorRe: INDESIT – ALL LIGHTS FLASHING – WIDL126
Error codes given by vertical lights only, all four flashing is a heater relay failure on the main pcb.
iadom
ModeratorRe: Miele W842 – accessing heater element?
Begs the question though, if you have not yet accessed the heater, how do you know you need to change it?
iadom
ModeratorRe: ISE10 1606W bearings
Try the Engineer search at the top of the page.
-
AuthorPosts
