Forum Replies Created
-
Posts
-
Re: Whirlpool AZB 8680 – Error code F02
F02 is a corrupt control board software problem and the control board retails for about £140 so is by no means cheap.
You could try to reset the control board by doing the following:
1) Turn the selector to the six o’clock position
2) push start button 3 times
3) turn selector clockwise one position to airing program
4) push start button 3 timesThen try it again, if this doesn’t work then it will need a new control board
HTH
John
Re: 20 FEBUARY 2015 Coventry meeting
kwatt wrote:Are you off your medication again? 😆
K.
Haven’t been taking it for years….I read the B&Q story this morning and wondered what special kind of pratt in B&Q’s head office sent that memo out.
John
Re: 20 FEBUARY 2015 Coventry meeting
If there is still space for another topic of discussion maybe Ken or Lawrence can do a presentation/training/Q&A on the Fifty shades of grey film.
We all keep insulation tape and cable ties in stock so it would be good to go prepared for any delicate questions from our customers who have watched the film.
I think the WTA should follow B&Q’s example and give out some guidance to it’s members :rotfl:
http://www.telegraph.co.uk/news/newstop … -rope.html
John
Re: In search of the fourth cord
Is Martin drunk this morning??? He has posted 3 times and all he says is “spam spam spam” :rolls:
John
Re: trade membership
Follow this link to gain access.
John
Re: Oven cleaning kits
For all the chrome shelves best ( and easiest ) I have used is he Oven Pride cleaner. Stick all the chrome in the supplied bag, pour in the cleaner and leave overnight. Then just rinse off with the garden hose and they come up as new.
John
Re: Don’t know how to describe this!!!!
Ron D wrote:
PS They are not Phillips screws holding the part in place. They are hexagon screws!
You are correct in that they are not phillips screws ( been a long time since I did this job ) they are either t10 or t15 torx IIRCJohn
Re: Don’t know how to describe this!!!!
It is this part that you will probably need
http://shop.ukwhitegoods.co.uk/48124181 … lter-cover
If you look at the holes that the spray arm pipe fits into you will see a rectangular slot cut into each one, these are what hold the pipe in place.On your machine there will be a crack at the top of the slot allowing the pipe to come loose when it is under pressure.
Easy to change just 4 phillips screws IIRC.
John
Re: Whirlpool AWZ7913 – tumble dryer – fault code
F14 fault, it looks like a heater short circuit or heater relay contacts welded. If it was short circuit you might be able to clear the fault by resetting,
turn selector to 6 o’clock position
push start button 3 times
turn selector clockwise 1 position
push start button 3 timesYou have to do this within 10 seconds.
John
Re: JTM struggling?
All you need to know in this post below.
HTH
Johnwhitegoods-trade-association/first4service-tej-vha-warrantysolutions-t81622.html?hilit=first4service
