Forum Replies Created
-
Posts
-
Re: Hotpoint WT761 G rear drum
C00144136 & C00144137 which is listed as the correct part for this machine. Confused
Jim the C00144136 comes without the heater and seal etc, the C00144137 comes with all the bits like the 1605082 rear half tub kit, JJRe: Hotpoint WT761 G rear drum
A WMA rear half wont fit as it is for a 6kg machine the WT761 is a 7 kg machine and both the front half, rear half and inner drum area little deeper, that is why there is a large gap, cross matching wma parts with 7 kg machines, the only way you could do it is fit a whole wma tub with balance weights, the 7 kg back half part n/o is C00144136
i’m sure connect were flogging it for under£40 on its own the last time i searched, JJRe: Hotpoint BSI620 Dishwasher
Sounds like a wash pump fault, duff motor, faulty capacitor or something in it jamming the impellor, JJ
Re: Updated labour charges from the Indesit Company.
Most of the chargeable calls are also sold a D & G policy usualy abot £60 plus a couple of boxes of descaler £20, not a good deal if it is only an out of balance or a blocked pump and nothing major.
Re: Updated labour charges from the Indesit Company.
On chargeable jobs its a mind boggling £25, g/tee calls are £16.50
Re: Baumatic DBW13 ???
I was at one of them yesterday Jim and i reckon its one of these chinese jobs, JJ
Re: PLC
Thanks for the advice John, i was thinking the same i’d have to change all my accounts etc seems a hell of a hassle just to save some tax, JJ
Re: Hotpoint AQGD 169S
you dont realy get much problems with these to be honest, i’ve never come across that fault before, i have had a couple of duff front pcbs i usaly plug one in from a WF machine and see if it lights up, as for the spare green wire thay all ahve that and serves no purpose as far as i can see. jj
Re: Swan SR2010 FRIDGE FREEZER
Cheers Helo was getting late i just defrosted and told her i would get back to her, i think you could be right about it being a Beko as the stat is in the roof just like the Bekos, jj
Re: Whirlpool PROA10
Cheers john thats the part i need, ive already replaced the timer because it was shot, the stat looked dodgy but i chanced it, its getting crazy now with the cost of parts JJ
Re: Hotpoint WMM75A No motor action
I f you hear the relay clicking i would be thinking it is more than likely a wiring or motor faultrather than the module, JJ
Re: Indesit D/Washer IDL40UKC – no heat
Itl be the 100 bit timer, 2 pcbs up to ser n/o 70914999 C00142139 from ser n/o 709150000 part n/o C00259733 hope this helps JJ
Re: no element tumble dryers !!
I’ve heard Indesit are bringing one out with a compressor in it, that should be fun and games on the quality front.
