[johnnyj]

Re: Indesit wd12x

Check the motor brushes would be my first port of call, JJ

[johnnyj]

Re: ZFD50/17R Fridge Freezer Thermostat

Cheers Bob i’ll have a lookee later

[johnnyj]

Re: ASE 3110

Thanks Mike i thought it would be, but thought i would give it a go if i could get the part, JJ

[johnnyj]

Re: WMA rear half with no holes to attach springs?

The 7kg back half doesnt have the holes for susp springs, as they are located on the front half, i made that mistake i put bearings in a 7kg back half and a 6kg back half, i put a 6 kg front half on the 7 kg back by mistake, it wasnt until i went to fit it i realalised what i had done, it could be that you have the wrong one.JJ

[johnnyj]

Re: WT741

C00045027 Filter kit comes with 3 types of filter, for various pumps, JJ

[johnnyj]

Re: Indisit WIA121 Motor connector block

Why not use 1605743 from connect about a fiver, it should fit okay JJ

[johnnyj]

Re: adg644ix

Thanks Mike i have cleaned a cuople of times for customer for not heating, i thought it would be that this customer uses it as a waste disposal unit, and has been advised to cscrape plates before using, JJ

[johnnyj]

Re: smeg uk st121 s.2 integ washer/dryer. Hotpoint fix ?

What i can remember the part was 168965 and i think it was connected to 21 and 12 on the level sw hope this helps JJ

[johnnyj]

Re: WF540 Valves

Part fginder shows it as a complete dispenser and valves part no c00143588 jj,

[johnnyj]

Re: snowed in !!!

I got a new van this year and wondered how it would cope, and up to now its been a breeze, compared with the last couple of Transits i had when i worked for Hotpoint they were a nightmare in the snow.

[johnnyj]

Re: Hotpoint FDW80G AL05 fault

Did you lay the machine down on the right hand side from the front to get access to the pump, if you did water can run up the pressure hose causing an air lock this can cause this fault, take the hose and blow through it, that may cure it JJ

[johnnyj]

Re: Hotpoint w/d condenser now obsolete?

I have one if you are desperate,

[johnnyj]

Re: Hotpoint FDW70G

Welcome to the mad house these are a disaster of a machine, check the heater and wiring which will more than likely be burnt out doing the module in also, requiring a harness or cable ends, possibly a heater?, a module and eeprom? which you put in and have to remove after fitting or it wont work. jj

[johnnyj]

Re: Is There A Difference

When they changed the part n/o it came complete with the heater panel attached, they then removed the panel and just supplied it as a heater assy only still using the new part n/o C00260053, JJ

[johnnyj]

Re: Hotpoint FDM550P wash pumps.

Yes had a few with the impellor falling off,jj

[Author]

Posts